Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Skrócona instrukcja obsługi - Strona 30

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco AIR-AP1020 - 1000 Series Lightweight Access Point. Cisco AIR-AP1020 - 1000 Series Lightweight Access Point 44 stron. Aironet 1000 series ieee 802.11a/b/g lightweight access points with external antennas

Drukuj stronę
Mounting the Cisco Aironet 1000 Series Lightweight Access Points

Flush Wall Mount

Flush Wall Mount
When you are mounting the Cisco Aironet 1000 Series lightweight access point against a wall (flat side
toward the inside of the building), use an optional separately orderable factory-orderable flush-mount
bracket.
1.
The Cisco Aironet 1000 Series lightweight access point threaded holes have precision-depth threads. Do
Note
not overtighten the screws, or the bracket will not fit under the screw heads.
Figure 13
2.
3.
4.
Note
•
•
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom
of the Cisco Aironet 1000 Series lightweight access point. Be sure the spring washers have their
convex (high center sections) pointing toward the screw heads.
Attaching the Mounting Screws and Spring Washers to the Cisco Aironet 1000 Series
Lightweight Access Point
A. Screws and spring washers
Copy the MAC address(es) from the label(s) on the Cisco Aironet 1000 Series lightweight access
point onto the corresponding location on the map. MAC addresses have the format 00xxxxxxxxxx.
You have already attached the flush-mount bracket to the wall in
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Be sure the side of the Cisco Aironet 1000 Series lightweight access point with the door is facing
away from the wall. This ensures that the correct antenna is facing the building, and makes future
upgrades easier.
If the screws do not securely hold the bracket, remove the Cisco Aironet 1000 Series lightweight
access point and adjust the screws until they securely hold the bracket.
Installation and Configuration
B. Completed assembly
"Preparing Mounting
Locations."
20