Cisco AIR-LAP1310G Instrukcja montażu - Strona 22
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Bezprzewodowy punkt dostępowy Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40 stron. Cisco aironet 1300 series lightweight outdoor access point
Drukuj stronęMounting the Access Point
Take down the mast.
Step 8
Mounting the Access Point
To mount the access point on the mast, follow these steps:
Attach the access point near the top of the mast.
Step 1
If the mast is the same diameter as the rooftop support, you can use the supplied hardware. The mounting
brackets accommodate a small mast (see
Mounting Hardware" section on page
Figure 6
1
1
1
Connect the ground lug on the access point to the mast using #6 gauge wire. Use a crimping tool to secure
Step 2
the wire to the ground lug. Use a mast clamp or tapped screws into the mast for the mast connections.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
22
Access Point Attached to a Small Mounting Pole
I S
T H
E
S I D
U P
2
U bolt (2 supplied)
Figure
6). For more information, see the
26.
1 5
0
1 5
2
Small mast, 1.25 to 2.5 inches
(30.5 to 63.5 mm) in diameter
"Assembling the
78-17634-01