DigitaLinx DL-HD70LSIR Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przedłużacz DigitaLinx DL-HD70LSIR. DigitaLinx DL-HD70LSIR 13 stron.
Również dla DigitaLinx DL-HD70LSIR: Podręcznik szybkiej instalacji (8 strony)
Drukuj stronę
DL-HD70LSIR Owners Manual
Connecting IR Control
The DL-HD70LSIR is capable of transmitting bi-directional IR signals through the HDBaseT circuit. The
DL-HD70LSIR comes with an IR receiver (eye) and an IR emitter (flasher) so you can control devices from either
end of the extender circuit.
Passing IR Signals:
The DL-HD70LSIR is capable of passing IR signals between 33 and 55 KHz. To prevent damage to
any of the electronics, the extenders should be powered off while inserting or removing any IR
components. Inserting an IR transmitter into the IR IN port may damage the IR circuit for that
extender.
Source Device Control using IR
Attach the IR emitter to the IR receiver of the source device, insert the TS 3.5 mm plug of the emitter to the IR
OUT port of the DL-HD70LSIR transmitter. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port
of the DL-HD70LSIR receiver. Point the source device IR remote at the display location where the IR receiver is
located, IR signals will now travel through HDBaseT to the DL-HD70LSIR transmitter side where the IR emitter is
attached to the source device.
Remote Display using IR
Attach the IR emitter to the IR receiver of the display device, insert the TS 3.5 mm plug of the emitter to the IR
OUT port of the DL-HD70LSIR receiver. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of the
DL-HD70LSIR transmitter. Point the source device IR remote at the source device location where the IR receiver
is located, IR signals will now travel through HDBaseT to the DL-HD70LSIR receiver side where the IR emitter is
attached to the display device.
Source / Display Control from Control System
To pass 3rd party IR system signals through the DL-HD70LSIR, such as a control system, connect the TS con-
nector of the IR-AC coupling cable (provided) to the IR output port of the control system and connect the TRS
connector of the IR-AC cable to the IR IN to either transmitter or receiver of the DL-HD70LSIR.
8