Cisco ASA 5508-X Skrócona instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco ASA 5508-X. Cisco ASA 5508-X 9 stron. Threat defense reimage guide
Również dla Cisco ASA 5508-X: Instrukcja instalacji sprzętu (32 strony), Skrócona instrukcja obsługi (8 strony), Instrukcja łatwej konfiguracji (11 strony), Instrukcja oprogramowania (37 strony), Montaż i połączenie (6 strony), Podręcznik (14 strony)

Cisco Firepower Threat Defense for the ASA 5508-X and ASA 5516-X Using Firepower Management Center Quick Start Guide

Procedure

Internet

Cable the following to a Layer 2 Ethernet switch:

—

GigabitEthernet 1/2 interface (inside)

—

Management 1/1 interface (for the Firepower Management Center)

—

A local management computer

Note:

You can connect inside and management on the same network because the management interface acts

like a separate device that belongs only to Firepower Management.

Connect the GigabitEthernet 1/1 (outside) interface to your ISP/WAN modem or other outside device. By

default, the IP address is obtained using DHCP, but you can set a static address during initial configuration.

5. Power on the Firepower Threat Defense Device

Procedure

Attach the power cable to the Firepower Threat Defense device and connect it to an electrical outlet.

Press the Power button on the back of the Firepower Threat Defense device.

Check the Power LED on the front of the Firepower Threat Defense device; if it is solid green, the device is

powered on.

Check the Status LED on the front of the Firepower Threat Defense device; after it is solid green, the system

has passed power-on diagnostics.

GigabitEthernet 1/1

outside, DHCP from Modem

GigabitEthernet 1/2

inside, 192.168.45.1

(Management Gateway)

WAN Modem

5. Power on the Firepower Threat Defense Device

Management 1/1

Default is 192.168.45.45

Layer 2 Switch

CONSOLE

Management Computer

192.168.45.2

Firepower

Management Center

192.168.45.44