Cisco Meraki MR36H Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Bezprzewodowy punkt dostępowy Cisco Meraki MR36H. Cisco Meraki MR36H 22 stron.

31/01/2022, 19:00

You should complete the following steps before going on-site to perform an installation.

Conﬁgure Your Network in Dashboard

The following is a brief overview only of the steps required to add an MR36H to your network. For detailed

instructions about creating, conﬁguring and managing Meraki wireless networks, refer to the online

documentation (documentation.meraki.com).

1. Login to http://dashboard.meraki.com. If this is your ﬁrst time, create a new account.

2. Find the network to which you plan to add your APs or create a new network.

3. Add your APs to your network. You will need your Meraki order number (found on your invoice) or the serial

number of each AP, which looks like Qxxx-xxxx-xxxx, and is found on the bottom of the unit. You will also

need your Enterprise license key, which you should have received via email.

4. Go to the map / ﬂoor plan view and place each AP on the map by clicking and dragging it to the location

where you plan to mount it.

Check and Set Firmware

To ensure your MR36H performs optimally immediately following installation, it is recommended that you

facilitate a ﬁrmware upgrade prior to mounting your MR36H.

1. Attach your MR36H to power and a wired Internet connection. See the "Power the MR36H" section for

details.

2. The MR36H will turn on and the LED will glow solid orange. If the unit does not require a ﬁrmware upgrade,

the LED will turn either green (no clients associated) or blue (clients associated) within thirty seconds.

* If the unit requires an upgrade, the LED will begin blinking orange until the upgrade is complete, at which point

the LED will turn solid green or blue. You should allow at least a few minutes for the ﬁrmware upgrade to

complete, depending on the speed of your internet connection.

Check and Conﬁgure Upstream Firewall Settings

If a ﬁrewall is in place, it must allow outgoing connections on particular ports to particular IP addresses. Check

the Meraki Dashboard under the help section for Firewall information.

Assigning an IP Address to the MR36H

All gateway MR36Hs (MR36Hs with Ethernet connections to the LAN) must be assigned routable IP addresses.

These IP addresses can be dynamically assigned via DHCP or statically assigned.

Dynamic Assignment

When using DHCP, the DHCP server should be conﬁgured to assign a static IP address for each MAC address

belonging to a Meraki AP. Other features of the wireless network, such as 802.1X authentication, may rely on

the property that the APs have static IP addresses.



How can we help you?

Static Assignment

https://documentation.meraki.com/MR/MR_Installation_Guides/MR36H_Installation_Guide

MR36H Installation Guide - Cisco Meraki



9/21