Cisco WET200 Wireless-G Business Ethernet Bridge Arkusz danych - Strona 2
Przeglądaj online lub pobierz pdf Arkusz danych dla Bezprzewodowy punkt dostępowy Cisco WET200 Wireless-G Business Ethernet Bridge. Cisco WET200 Wireless-G Business Ethernet Bridge 4 stron. Wireless-g business ethernet bridge business access points
Drukuj stronę
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
wireless networks, enabling the deployment of business-quality voice over IP (VoIP) and video
applications.
Additional support for VLANs, Simple Network Management Protocol (SNMP), Spanning Tree
Protocol, and port mirroring make this an ideal solution for network administrators to incorporate
into larger organizations.
RangeBooster technology is a compatible add-on to standard Wireless-G that nearly doubles the
wireless signal range and increases throughput by up to 35 percent. Unlike ordinary wireless
technologies that are hampered by signal reflections, RangeBooster devices use smart antennas
and embedded processors to detect and decode reflected signals to enhance and boost data
throughput. This capability also helps to reduce or eliminate "dead spots" within the wireless
coverage area.
Features
5-port 10/100 BASE-T Ethernet managed switch, autosensing half/full duplex and medium
●
dependent interface (MDI) and MDI crossover (MDI-X)
Supports 802.11b and 802.11g wireless connection to access point
●
Easy installation and configuration via a web interface
●
Supports Wired Equivalent Privacy (WEP), WPA Pre-Shared Key (WPA-PSK), WPA2-PSK,
●
WPA-ENT, and WPA2-ENT wireless encryption
Supports 802.1X, Extensible Authentication Protocol Transport Layer Security (EAP-TLS),
●
and Protected EAP (PEAP) authentication with RADIUS server
SMA detachable dipole antennas with 1x2 multiple-input, multiple-output (MIMO) to
●
increase coverage
Supports PoE or external DC power
●
Supports SNMP and features an intuitive web-based interface
●
Support 802.1Q and port-based VLAN on LAN switch - 1 VLAN bridged over wireless
●
Support 802.1p, IP type of service (ToS), and differentiated services code point (DSCP)
●
based QoS on LAN switch
Supports rate limiting on both wired switch and wireless interface
●
Supports Spanning Tree Protocol, port mirroring, and MAC-based access control lists
●
(ACLs)
Specifications
Table 1 lists the specifications, package contents, and minimum requirements for the Cisco
WET200 Wireless-G Business Ethernet Bridge.
Table 1.
Specifications for the Cisco WET200 Wireless-G Business Ethernet Bridge
Specifications
Standards
Ports
Buttons
Cabling type
LEDs
IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS
priority), 802.1Q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2),
802.11e ready (wireless QoS)
Five 10/100 BASE-T Ethernet, 12V DC power
Reset
Unshielded twisted pair (UTP) Category 5
Power, PoE, Wireless, Ethernet 1-5
Data Sheet
Page 2 of 4