Digitana VCS3 MKII Quad Midi-CV Podręcznik użytkownika - Strona 12
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający Digitana VCS3 MKII Quad Midi-CV. Digitana VCS3 MKII Quad Midi-CV 13 stron.
Drukuj stronęmessage is received. Meanwhile CV3 is set to Pitch Bend (green box ) and finally CV4 corresponds
to the Midi Volume (Coarse). In addition the '+5V' option is also checked, which means the
maximum swing of CV4 = +5v. So a Midi Volume value of 0 gives 0V on CV4 whereas a Midi
Volume value of 128 sets CV4 to +5V.
Limiting the maximum swing to +5V can be useful and give better resolution/response
depending on what control destination on the VCS3 you are routing the CV.
Notice in this example all the text in the first 3 DAC boxes is greyed and CC boxes are
'unchecked'. This is because we have used up 3 DAC assignments. Two are used for Midi note 1
and Midi note 2 CV, the third on Pitch Bend CV. This only leaves CV4 (DAC3) which to freely
assign a Midi CC. Similarly looking at the Gate CC's assigned. G1 and G2 are greyed out because
they are automatically assigned to Midi note1 and note 2 'on' events. This leaves G3 and G4
assignable to a Midi CC.
Here is another example which sets the Quad Unit again to Mono play mode.
Thus CV1 is automatically assigned to midi note1 value. This leaves CV2-CV4 freely assignable to
PB, VL, or a CC. In the example CV2 is assigned to Modulation Wheel (Coarse) CC, CV3 to Pitch
Bend and CV4 to Expression (Course) CC. In addition maximum swing of CV3 and CV4 is limited
to +5v.
G1 is automatically assigned to Midi note 1 on message. But G2-G4 can be freely assigned to Midi
CC's. In the example G2-G4 are assigned to controllers 15, 20 and 21.
Finally, if you click either the 'send to Midi' or 'Write to Flash' buttons you will see the Midi
activity led flash briefly as the processor is updated. Writing to Flash means the unit will
remember the play mode change even after power down.