CabKing 6V3 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sander CabKing 6V3. CabKing 6V3 20 stron.

Pre-polishing — Once you are done grinding and shaping your cabochon on the electroplated

diamond wheels, proceed to the resin wheel sequence. Resin wheels sand and smooth away flat

spots, scratches and tiny bumps that are left behind from the grinding wheels in your stone,

resulting in a pre-polished cabochon.

Important notes: The supplied CabKing resin wheels are formulated to be used exclusively

together in sequence. To avoid scratching or uneven grinding/polishing, do not mix and match

other brands of resin wheels with the CabKing resin wheels. PLEASE READ THE RESIN WHEEL

NOTICES DOCUMENT THAT IS INCLUDED WITH YOUR INSTRUCTION MANUAL.

The resin wheel sequence starts with the 280# resin wheel and proceeds to the 600#, 1200# and

lastly, the 3000#. Thoroughly grind and smooth your stone on each wheel, moving onto the next

wheel when finished. After you complete the resin wheel sequence, your cabochon will be ready

for polishing. Adjust the lamp as you work to provide additional light.

Polishing — To put the final polish on your stone, attach the included canvas polishing pad by

screwing it into the end of the right wheel assembly while the machine is turned off. Using the

included 14,000 mesh diamond paste syringe, apply a series of small dots, randomly throughout

the pad, starting from the center of the pad, moving to the outer edge of the pad. Using your

finger, smear the small dots into the canvas polishing pad. While diamond paste puts a bright,

shiny polish on most stones, there are other ways to polish your stones such as using diamond

powder or cerium oxide.

Now that the canvas polishing pad is charged with the diamond

paste, it is ready for use. Most diamond pastes can be used

without water however, you may use water while your polishing.

To use with water, aim the black side spray tube to the center of

the disc. You want to aim the side spray tube to the center of the

disc because when the disc is spinning, the water will spread

evenly throughout the surface of the canvas polishing pad. Easily

adjust the water drip to your preference by moving the black side

spray tube and white nozzle to the left or right (FIG. H). Important

note: Only use one mesh per canvas polishing pad. Do not mix

different mesh on the same canvas polishing pad.

FIG. H

If you plan to insert your polished cabochon into a jewelry finding, you will need to put a flat on

the backside of your cabochon. To do this, attach the included full face diamond lap by screwing

it into the end of the right wheel assembly while the machine is turned off. The full face diamond

lap must be used with water. Just like the canvas polishing pad, aim the black side spray tube to

the center of the disc and adjust the water drip to your preference by moving the black side

spray tube and white nozzle to the left or right.

Important note: The canvas polishing pad and full face diamond lap are to be used on the right

shaft ONLY.