CabKing 8V1 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Tokarka CabKing 8V1. CabKing 8V1 20 stron.

5. Remove the top nuts and washers located on the four bolts

sticking through the baseboard (FIG. B). Keep these aside, you

will need them for the motor. Remove the plastic protectant

from the baseboard.

6. Install the lamp onto the baseboard. To do this, open the lamp

box and take out the lamp, rubber seal and three Phillips

screws. Using the pre-drilled holes in the baseboard as a

template, secure the lamp with the three Phillips screws,

making sure the rubber seal is between the baseboard and the

lamp. The lamp's power cord needs to be facing away from the

motor (FIG. C).

7. Remove the motor from its box by lifting the motor straight

upwards by its black housing. Do not lift the motor by its shafts.

The motor comes in its own crate for shipping purposes. There

is an included wrench inside the crate. Use this to remove the

nuts that secure the motor in the crate.

8. Once the motor is removed from the crate, place it onto the four

bolts found on the baseboard. Make sure to align the motor so

it is parallel to the board, then take the washer and nuts you

placed aside earlier and tighten them onto the bolts using the

same wrench used to take the motor off the board.

9. Wheel installation — Refer to FIG. D below for step 9. There are two arbors that are

included with your CabKing. The left arbor is located at the end of the left motor shaft.

The right arbor is located at the end of the right motor shaft. Unscrew and remove the

left and right arbors from the motor shafts using the included shaft wrench. Remove

the spacers that are included on the shafts. Install the wheels and spacers onto the

shafts according to FIG. D below. Once the wheels and spacers are properly installed,

replace and tighten the arbors onto the shafts using the shaft wrench.

80#

Left arbor

3-1/2" spacer

220#

280#

3" spacer

600#

2-1/2" spacer

FIG. D

FIG. B

FIG. C

3000#

1200

Right arbor

2-1/2" spacer