Cable Bullet YYQ-300 Instrukcje
Przeglądaj online lub pobierz pdf Instrukcje dla Narzędzie do zaciskania Cable Bullet YYQ-300. Cable Bullet YYQ-300 2 stron. Modified 16t manual hydraulic crimper
Drukuj stronęThe Cable Bullet crimper is a modified YYQ-300 16-ton manual
hydraulic crimper equipped with a custom die set
for use with Cable Bullet crimp sleeves and 5/32" diameter cable.
ATTACHING THE CRIMPER STAND
move the nut
B
from the crimper pin
D
and lock it in place by re-attaching the nut.
PRO TIP: Place your crimper on a protective surface to avoid
inadvertently damaging softer or finished floors during the
crimping process.
USING THE CRIMPER
To engage the crimper, turn the knob
the ON position. Begin pumping the movable handle
the piston and close the die. Continue pumping until the two halves
of the die have securely closed around the crimp. The amount of
effort required will vary. A properly seated crimp will have a distinct
hexagonal imprint G. If your finished crimp shows only a faint im-
pression H, repeat the process with additional force.
To release the dies, turn the knob to the OFF position.
IMPORTANT: Check your first few crimps and adjust your
process as needed. A weak crimp may fail under tension,
compromising your railing. However, excessive pressure
beyond what is required may damage the crimper tool.
CRIMPER TOOL INSTRUCTIONS
MODIFIED Y YQ -300 16T MANUAL HYDR AULIC CRIMPER
A
designed
Before getting started, re-
C
. Attach the crimper stand
E
to
F
to advance
GOOD CRIMP
BAD CRIMP