Cable Electronics AV400COMP Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Cable Electronics AV400COMP. Cable Electronics AV400COMP 2 stron. Audio/video distribution amplifiers

Drukuj stronę

GENERAL INFORMATION

The AV400COMP allows any audio/video source with Y, Cb, Cr, or Y, Pb, Pr
application outputs (component), to distribute audio and video. The signal
ratio is true one to one with no loss from original source to four different
locations. These locations must have the same application as your
audio/video source.
A
B
A. 9 Volt AC input jack at 500mA with 2.1 mm power jack. LED lights
up when power is applied.
B. Input Jacks: Connect to original source at corresponding output
jacks Video connections are coded (Y to Y, Cb to Cb, Cr to Cr, or Y
to Y, Cb to Pb, Cr to Pr) with audio connections being color coded
(red to red, white to white)
C. Output Jacks: Connect to corresponding input jacks of TVs, VCRs,
etc.
SAFETY INSTRUCTIONS
Location: Avoid locations with strong vibrations, direct sunlight or intense
heat.
Avoid Electrical Schock: Do not handle power cord with wet hands; do not
expose to rain or other moisture. If liquid is spilled on unit, unplug and have
unit serviced at authorized service center. To reduce the risk of electrical
shock, do not remove cover. No user serviceable parts inside.
KEY INFORMATION
The AV400COMP can be looped, cascaded or put in tandem as shown
without loss of audio/video signals. Maximum total runs using multiple
amplifiers should be limited to 150 feet for optimum performance.
C
Common Audio/video Sources:
VCR, CD, Satellite receiver, etc.
Audio/Video Source
H GH ER ORMANCE
AUD O AND VIDEO
D S RIBU ION AM
I IER
ou Ou pu
T ue One To One Ra o
A
T
M
e 4
H GH ER ORMANCE
AUD O AND VIDEO
D S RIBU ION AM
I IER
ou Ou pu
T ue One To One Ra o
A
T
M
e 4
H GH ER ORMANCE
AUD O AND VIDEO
D S RIBU ION AM
I IER
ou Ou pu
T ue One To One Ra o
A
T
M
e 4
SPECIFICATIONS
VIDEO
Gain:
1 Volt, Unterminated 2 Volt
Input Impedance:
75 Ohms +5%
Video Response:
50 Hz to 100 MHz <0.4dB
Ch. to Ch. Isolation:
50 Hz to 10 Mhz 32 dB
Out to In Isolation:
50 Hz to 10 MHz 60 dB
Return Loss:
50 Hz to 10 MHz 20 dB
AUDIO
Gain:
Unity
Input Impedance:
22 K Ohm
Output Impedance:
100 Ohm
THD:
0.05% at 1.0 Volts input level
Frequency Response:
10 to 50 KHz + 1 dB
Channel Separation:
> 75 dB @ 1 KHz
Out to In Isolation:
60 dB
Signal to Noise:
100 dB (re: 2 Volts out)