Cisco Profile Series Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System konferencyjny Cisco Profile Series. Cisco Profile Series 16 stron. Jbod on the 12g sas modular raid controller
Również dla Cisco Profile Series: Podręcznik dla początkujących (41 strony), Podręcznik użytkownika (44 strony), Podręcznik użytkownika (7 strony), Podręcznik dla początkujących (35 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja instalacji (44 strony), Podręcznik konfiguracji (13 strony), Arkusz instalacyjny (2 strony), Instrukcja instalacji (2 strony), Skrócona instrukcja obsługi (4 strony), Skrócona instrukcja obsługi (4 strony), Podręcznik dla początkujących (32 strony), Podręcznik (16 strony), Podręcznik dla początkujących (42 strony), Podręcznik dla początkujących (46 strony)

Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not

Warning

stack routers on a desktop. Excessive weight on top of the router could damage the chassis.

Do not install the router or power supplies next to a heat source of any kind, including heating vents.

Warning

A four rubber feet is provided as part of the router hardware (shown in

table mount while ordering. Insert the rubber feet at the bottom of the router. Connect the chassis to a

reliable earth ground. Keep at least 200 mm of clear space on both left and right side for heat dissipation.

Figure 2-1

Two brackets and six counter-sunk screws are provided as part of the router hardware. These brackets

and screws can be used for both rack mount and wall mount and the brackets can be oriented in different

angles based on the need for wall mount and rack mount.

For wall mount, the supported configurations for the router are:

•

Tip

When choosing a location for wall-mounting the router, consider cable limitations and wall structure.

To mount the router on a wall, follow these steps:

Attach the two brackets to the chassis using the three screws provided for each bracket such that the

Step 1

brackets are facing the bottom of the router, as shown in

Step 2

Orient the Cisco 800M Series router, facing the I/O side facing upwards as shown in

the opposite direction such that the I/O side is facing downwards as shown in

Cisco 800M Series Integrated Services Router Hardware Installation Guide

2-4

Four Rubber Feet

I/O side facing upwards, as shown in

I/O side facing downwards, as shown in

Figure 2-2

Figure 2-3

Figure

2-2.

Chapter 2

Figure

2-1) if you have opted for

Figure

2-2, or in

Figure

2-3.