Cisco SX series Podręcznik dla początkujących - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla System konferencyjny Cisco SX series. Cisco SX series 33 stron. Telepresence video systems
Również dla Cisco SX series: Podręcznik dla początkujących (34 strony), Podręcznik dla początkujących (46 strony)
Drukuj stronę
Cisco TelePresence Video Systems
Introduction
On-screen menu when using a remote control
When you start the system for the first time, the Setup assistant
starts automatically.
Read how to configure the system with the on-screen setup
assistant on page 20.
Settings menu
After the initial set up, you can revisit the configurations and
more in the Settings menu:
• Language: Select a language for the user interface.
• Time zone: Select your local time zone.
• Screen adjustment: Adjust display and system settings for
correct rendering of video and graphics.
• Network connection: Change the IPv4 settings, if those
have not been configured by autoprovisioning or the
network. VLAN settings are also available.
• Service activation: Change provisioning settings, if those
have not been configured by autoprovisioning.
• Microphone check: Check that the microphone is working.
If you are using an external microphone, use this test to
adjust its location.
• Sound test
• Default camera preset: Set the default camera position for
future calls.
• Presentation: Test presenting from your computer. You
need an HDMI or VGA cable for this.
• Factory settings: Reset your video system to its factory
settings, and you lose your current registration. You cannot
undo a factory reset.
• Extended logging: Helps diagnose network issues and
problems during call setup. While in this mode more infor-
mation is stored in the log files. Extended logging uses
more of the system's resources, and may cause it to
underperform. Only use extended logging mode when you
are troubleshooting an issue.
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.
User interfaces
User interfaces
Web interface
On-screen setup assistant
• Proximity
• Do not disturb
• System Information
• Standby
To access the Settings menu, navigate to
upper left corner of the screen and press
on the remote control. Then navigate down
to System Information and press
OK
again.
The System Information menu shows the
basic system information and potential
issues the system might have. You can also
restart the system from this page.
In addition this page provides access to
the Settings menu. These settings can
be protected with a PIN set from the web
interface.
9
Touch
Place calls
OK
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Appendices
Camera
Control
Share content