Cisco SX series Podręcznik dla początkujących - Strona 17
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla System konferencyjny Cisco SX series. Cisco SX series 34 stron. Telepresence video systems
Również dla Cisco SX series: Podręcznik dla początkujących (33 strony), Podręcznik dla początkujących (46 strony)
Drukuj stronę
Cisco TelePresence Video Systems
Introduction
Configure H.323 and SIP
(When not set by a provisioning system)
To get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SIP protocol for video calls.
The diagnostics on your system will indicate if there is a
problem with H.323 or SIP registering.
If you wish to change the other H.323 or SIP settings, see the
administrator guide for your product.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite), your Cisco TMS adminis-
trator will help you to get online.
You can find information about administering through Cisco
UCM in the
Administering CE endpoints on CUCM
If you are changing a value setting,
you have to always click
save
to confirm the change.
D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.
User interfaces
Web interface
Web interface
H.323
If in doubt for any of the parameters below, contact your system
administrator or your service provider.
1. Go to the
2. Open the
3. Under the
number in the corresponding input fields.
4. Enter the
field.
5. If the H.323 gatekeeper requires authentication, and you
guide.
want your system to authenticate itself to the gatekeeper,
go to the
the
Mode
Password
Otherwise, select
Setup assistant
Setup
tab, and select Configuration.
H323
settings from the left sidebar.
H323Alias
heading enter the
E164
and the
Gatekeeper Address
in the corresponding input
Authentication
subheading and select
drop down list. Then enter the
LoginName
in the corresponding input fields.
Off
in the
Mode
drop down list.
17
Touch
SIP
If in doubt for any of the parameters below, contact your system
administrator or your service provider.
1. Go to the
Setup
tab, and select Configuration.
2. Open the
SIP
settings from the left sidebar.
ID
3. Enter the SIP URI in the
display name in the
DisplayName
4. Select the preferred transpor t protocol from t h e
DefaultTransport
drop down list. If you select Auto, the
system first tries to connect using Tls, then TCP, and finally
UDP.
On
in
5. Select a proxy type in the
and
type is Standard. You can use
CUCM.
6. Enter the
Proxy 1 Address
7. If the SIP proxy requires authentication, you must enter a
login name and password to authenticate your system. Go
to the
Authentication
heading and enter the
Password
in the corresponding input fields.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Appendices
URI
input field, and optionally a
input field.
Type
drop down list. The default
Cisco
when registering to
in the corresponding input field
LoginName
and