Argo dados 40 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator Argo dados 40. Argo dados 40 11 stron. Local air conditioner

If the remote control is not working or has been lost, the button on the control panel can be used.

1. "POWER" BUTTON

(SWITCHING ON/FUNCTION SELECTION (Cooling/Heating/Fan/Switching off)

By pressing this button consecutively on the control panel, the unit is activated, cooling mode is selected, heating mode

is selected, ventilation mode is selected and finally the appliance is deactivated.

For Dehumidification mode, always use the remote control.

WARNING!

Before carrying out any cleaning or maintenance, unplug from the electric socket.

1. Cleaning the air filters.

before replacing. Once the two filters have been replaced, close the grilles once again and return to using the air-

conditioner.

2. Cleaning the casing.

Use a damp and soft cloth to clean the exterior surface of the air-conditioner.

Do not use water that is too hot, solvents, petrol or other aggressive

chemical compounds, talcum powder or brushes: these may damage the

surface or colour of the casing.

To remove stains use warm water with a little neutral detergent.

Do not pour water onto the air-conditioner to clean it: this may damage the

internal components or cause a short circuit.

3. Storage.

When you do not envisage using the air-conditioner for a long time, before storing it away, clean the filters.

Keep the appliance in a vertical position at all times. Do not rest heavy objects on the

top and, if possible, protect the air-conditioner with a sheet of plastic.

V 07/13

OPERATION WITHOUT A REMOTE CONTROL

The air filters must be checked at least once

every two weeks of use. Operating with dirty

or blocked filters will decrease the

effectiveness of the air-conditioner and can

cause serious problems.

To remove the filters, release the two upper

sides of the side suction grilles and leave

them in an inclined position, resting on the

lower side: now remove the filters, pulling

them delicately upwards.

Use a vacuum cleaner to remove dust. If

this should not suffice, wash the filters with

warm water and a neutral detergent if

necessary.

Rinse with cold water and leave to air dry