Cisco TelePresence IX5200 Pierwsza konfiguracja - Strona 9
Przeglądaj online lub pobierz pdf Pierwsza konfiguracja dla System konferencyjny Cisco TelePresence IX5200. Cisco TelePresence IX5200 40 stron.
Również dla Cisco TelePresence IX5200: Skrócona instrukcja obsługi (15 strony), Podręcznik użytkownika (26 strony), Instrukcja instalacji (36 strony)
Drukuj stronę
Figure 2
Bootup Screen
c.
Note the IP address that displays on the top right of the screen as shown in
Step 2
already booted, tap the top left of the Touch 10 controller, then tap Info, and note the system IP address.
You use that information to sign in to the Cisco TelePresence System Administration. This IP address
displays until you sign in to Cisco TelePresence System Administration or use Secure Shell (SSH) to
sign in to the IX5000.
Note
If the IP address that displays is 192.168.100.2, the system could not contact the DHCP server or your
system does not use DHCP. If your network does not use DHCP, set a static IP address for your system
as described in the
on page
If you have not already done so, configure the Cisco Unified Communications Manager GUI. For
Step 3
detailed instructions to configure Cisco Unified Communications Manager, refer to the
Cisco Unified Communications Manager for the IX System
Step 4
Open a browser on a computer that is connected to your network.
In the URL field, type the IP address that you obtained in
Step 5
Cisco TelePresence System Administration.
If you did not make a note of the IP address and it no longer appears on the display, tap the number that
Tip
displays on the top left corner of the Touch 10 controller, then tap System Info.
OL-27038-01
Powering on the System and Enabling the Cisco TelePresence Administration Software GUI
Watch the main display screen as the system is booting.
"Configuring an IX5000 or IX5200 System With a Static Network Address" section
10.
document.
Step 2
and press Enter. The browser launches
Cisco TelePresence IX5000 and IX5200 First-Time Setup
Figure
2. If your system has
Configuring
9