Cisco Telepresence MX200 Instrukcja rozwiązywania problemów - Strona 33

Przeglądaj online lub pobierz pdf Instrukcja rozwiązywania problemów dla System konferencyjny Cisco Telepresence MX200. Cisco Telepresence MX200 37 stron. Table stand
Również dla Cisco Telepresence MX200: Podręcznik użytkownika (44 strony), Podręcznik dla początkujących (42 strony), Podręcznik dla początkujących (35 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (12 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja instalacji (6 strony), Podręcznik dla początkujących (46 strony)

Drukuj stronę
Cisco Telepresence MX200 Instrukcja rozwiązywania problemów
Appendix B – Gaining root access to your system
root access is disabled by default from TC4 onwards. However it can occasionally be useful to enable
this for troubleshooting.
it is critical to always set a password when enabling root access.
To enable root access login as admin and use the command:
systemtools rootsettings on [password]
replace [password] with the actual password you want to set for root access. When you enter this
command, your telnet/SSH session will close. After this you are able to login as root.
To check if root is enabled you can login as admin and enter:
systemtools rootsettings get
The system returns:
systemtools rootsettings get
on
OK
To turn off root access (default state):
systemtools rootsettings off
D15029.01 Troubleshooting Guide TC6.0, April 2013.
Appendix C – Serial connections
The C40, C60 and C90 have standard serial port interfaces. profile systems containing these codecs
will also have standard serial connectors.
The EX, MX and SX series need non-standard cables to access their serial ports. These should be
available to order in the near future, please contact your local Cisco representative for more details
on orderability.
With a modern pC or laptop with no standard serial connector, you will need a USB to serial adaptor
like the one illustrated here.
Model
Parameter
C Series, EX, MX, SX,
Baud rate
Profile
Data Bits
parity
Stop Bits
Flow Control
The default baud rate is shown above. This can be changed on the system and it is worth checking
other baud rates if you are having connection problems. The port can be disabled. You can check the
serial port settings on the web interface by going to
33
Troubleshooting Guide TC6.0
38400
8
None
1
None
Configuration -> System Configuration –>
Copyright © 2013 Cisco Systems, Inc. All rights reserved.
SerialPort.