Cisco TelePresence MX700 Podręcznik dla początkujących - Strona 29

Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla System konferencyjny Cisco TelePresence MX700. Cisco TelePresence MX700 46 stron. Single camera on a free standing floor stand or a floor stand secured to the wall
Również dla Cisco TelePresence MX700: Instrukcja instalacji (32 strony), Skrócona instrukcja obsługi (12 strony), Instrukcja instalacji (28 strony), Instrukcja instalacji (29 strony), Instrukcja instalacji (32 strony), Skrócona instrukcja obsługi (2 strony), Podręcznik (45 strony), Podręcznik (45 strony), Instrukcja instalacji (29 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Cisco TelePresence MX700 Podręcznik dla początkujących

Cisco TelePresence Video Systems

Contents

Setup assistant for SX10

When you start the system for the first time, the Setup assistant

starts automatically.

On first time setup, you will be prompted for a software upgrade.

We recommend that you wait for the software upgrade message

and upgrade before you continue on the setup assistant.

•

If you do decide to upgrade mid setup, changes to the

settings will not persist.

•

If you choose to postpone the software upgrade, you will

be prompted again in six hours.

If your system is automatically provisioned, the IP and provision-

ing settings are automatically configured. To keep the automatic

settings, skip these stages on the Setup assistant.

Start the Setup assistant

Navigate to the upper left corner on the home screen and press

on the remote control.

Navigate to

Settings

and press OK. Navigate to

and press OK. Follow the instructions on screen.

If the system does not show a menu on screen:

•

Make sure the monitor is connected and has been switched

on.

•

Make sure that the correct input is selected on the monitor.

•

Make sure the remote control has batteries installed.

•

Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If there is still no menu on screen, make sure the monitor cable

is connected to the video output connector. If in doubt, see the

installation guide for your product.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Setup assistant

Configuration

On-screen display

Getting Started Guide

Appendices

Contacts