ACU-RITE 00888 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Termometr ACU-RITE 00888. ACU-RITE 00888 2 stron. Thermometer with wired temperature probe

Drukuj stronę

Slide the battery compartment cover open and install 1 fresh "AAA" battery as

shown here. Make certain the "+" and "-" polarity markings on the battery match

the markings within the battery compartment. Replace the battery with a fresh one

when the display starts to fade or when the unit stops functioning.

Select °C or °F

temperature display

Install 1

"AAA"

battery

Slide to remove the battery

compartment cover

PRODUCT REGISTRATION

To receive product updates

and information, Go to

www.AcuRite.com

> Register a Product

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY

SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from

equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove

dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO

NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of

batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply

terminals.

Now that setup is complete, you must choose a location to place the thermometer.

When considering placement options, be sure to choose an area free of water, dust

and direct heat that may effect the accuracy of the temperature readings on the

thermometer.

To observe outdoor temperatures, the wired temperature probe must be placed

outside. The probe sensor then can be securely mounted to a surface utilizing the

adhesive pad or the integrated screw/nail hole. Take care

not to damage the sensor during mounting.

A common routing option would be to open a

window, and route the wire through that opening.

Then gently close the window frame on the sensor

wire, making sure there are no sharp or binding

surfaces that may sever or cut the wire.

NOTE: The wired temperature is not intended for permanent submersion

installation in liquids, but may be used short term to check shallow water

temperatures.

You may switch between viewing the current indoor OR outdoor temperature by

sliding the "IN/OUT" slide select switch.

You may view the MAX/MIN recorded values for temperatures and humidity by

pressing the "MAX/MIN" button for temperature, or the "MAX/MIN" button for

humidity. The MAX and MIN indicators will appear on the display. To clear the

currently viewed MAX/MIN values, press the "CLEAR" button.

SPECIFICATIONS

Batteries: | x "AAA" (not included)

eee

ETT]

Measurement Ranges

Outdoor Temperature: -58°F to 140°F

HECHO

EN CHINA

-50°C to 70°C

Limited One Year Warranty

————

Instructions & Warranty Enclosed

Indoor Temperature:

-32°F to 122°F

Customer Care:

OC to md C

877-221-1252

The thermometer will display "LO" or "HI" when temperature or

www.AcuRite.com

humidity readings reach a level out of the range stated above.

area

nee

Patent numbers: 5,978,738; 6,076,044; 6,597,990;

ACURITE?® is a registered trademark of the Chaney Instrument Co.

Lake Geneva, WI 53147