cable matters 201078 Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Obudowa cable matters 201078. cable matters 201078 12 stron. Usb 3.1 type-c gen 2 dual-bay external m.2 ngff sata enclosure

Drukuj stronę

5. Troubleshooting Notes

DO NOT reset the storage configuration mode (JBOD/RAID0/RAID1/BIG) and press the reset

button if there is any important data on the SSD. Back-up the data first.

Check with the SSD manufacturer for management and diagnostic software.

Disconnect and turn-off the Enclosure, reboot the computer, and then reconnect the Enclosure.

Hot-swapping of the SSD drives is not supported and may corrupt the data.

A USB-C Gen 2 port should provide sufficient power for the enclosure. Connect the DC to USB power

cable and a wall charger if the LEDs will not light or the light is purple after the SSD is inserted.

Do not connect the DC to USB power cable BEFORE connecting the USB cable to the computer.

Disks previously formatted as RAID0 or RAID1 with another computer or enclosure may not be

readable in this Enclosure. Back-up the data to another disk and re-format the disks with this

Enclosure.

Try a different storage configuration mode (JBOD/BIG/RAID0/RAID1) as a test if new SSD disks are

not recognized.

Try a different USB-A or USB-C port on the computer.

Test the USB cable with a different device.

Windows OS:

Check to see if your computer recognizes the Enclosure: Device Manager > Storage controllers > USB

Attached SCSI (UAS) Mass Storage Device

macOS:

Check to see if your computer recognizes the Enclosure: About this Mac > System Report > USB

Device Tree

> USB 3.1 Bus > MiniRAID

Contact [email protected] for a warranty replacement if you believe

that the Enclosure is defective. If your SSD disks were formatted in the Enclosure,

they can be inserted into the replacement and the storage configuration format

will be recognized.

USB 3.1 Type-C™ M.2 SATA Dual-Bay Enclosure