Sony CCU-590P Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kamera Sony CCU-590P. Sony CCU-590P 18 stron. Camera contol unit
Również dla Sony CCU-590P: Broszura i specyfikacje (14 strony), Instrukcja obsługi (18 strony)

Drukuj stronę

WARNING

To reduce the risk of fire or electric shock,

do not expose this apparatus to rain or

moisture.

To avoid electrical shock, do not open the

cabinet. Refer servicing to qualified

personnel only.

THIS APPARATUS MUST BE EARTHED.

WARNING:

Using this unit at a voltage other than 120 V may require the

use of a different line cord or attachment plug, or both. To

reduce the risk of fire or electric shock, refer servicing to

qualified service personnel.

This symbol is intended to alert the user to

the presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the appliance.

Attention-when the product is installed in Rack:

1.Prevention against overloading of branch

circuit

When this product is installed in a rack and is supplied

power from an outlet on the rack, please make sure that the

rack does not overload the supply circuit.

2.Providing protective earth

When this product is installed in a rack and is supplied

power from an outlet on the rack, please confirm that the

outlet is provided with a suitable protective earth

connection.

3.Internal air ambient temperature of the rack

When this product is installed in a rack, please make sure

that the internal air ambient temperature of the rack is

within the specified limit of this product.

4.Prevention against achieving hazardous

condition due to uneven mechanical loading

When this product is installed in a rack, please make sure

that the rack does not achieve hazardous condition due to

uneven mechanical loading.

5.Install the equipment while taking the operating

temperature of the equipment into

consideration

For the operating temperature of the equipment, refer to the

specifications of the Operation Manual.

6.When performing the installation, keep the

following space away from walls in order to

obtain proper exhaust and radiation of heat.

Right, Left : 4 cm (1.6 inches) or more

Rear : 10 cm (4 inches) or more

For the customers in the U.S.A. (for CCU-590)

This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment

is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own

expense.

You are cautioned that any changes or modifications not

expressly approved in this manual could void your authority

to operate this equipment.

All interface cables used to connect peripherals must be

shielded in order to comply with the limits for a digital device

pursuant to Subpart B of Part 15 of FCC Rules.

For the State of California, USA only

Perchlorate Material - special handling may apply, See

www.dtsc.ca.gov/hazardouswaste/perchlorate

Perchlorate Material : Lithium battery contains perchlorate.

For the customers in Europe (for CCU-590P)

This product with the CE marking complies with both the

EMC Directive and the Low Voltage Directive issued by the

Commission of the European Community.

Compliance with these directives implies conformity to the

following European standards:

• EN60950-1 : Product Safety

• EN55103-1 : Electromagnetic Interference (Emission)

• EN55103-2 : Electromagnetic Susceptibility (Immunity)

This product is intended for use in the following

Electromagnetic Environments:

E1 (residential), E2 (commercial and light industrial), E3

(urban outdoors), E4 (controlled EMC environment, ex. TV

studio)

For the customers in Europe (for CCU-590P)

The manufacturer of this product is Sony Corporation, 1-7-1

Konan, Minato-ku, Tokyo, Japan.

The Authorized Representative for EMC and product safety is

Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327

Stuttgart, Germany. For any service or guarantee matters

please refer to the addresses given in separate service or

guarantee documents.

For kundene i Norge

Dette utstyret kan kobles til et IT-strømfordelingssystem.

For the customers in Taiwan only