DigiTech XC0438 Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Stacja pogodowa DigiTech XC0438. DigiTech XC0438 16 stron. Smart wi-fi weather station lcd colour display

Drukuj stronę

1. Installation and Setup

SETUP THE CONSOLE

INSTALL THE BACKUP BATTERY

Backup battery provides power to the console to retain clock time and date, max/min records

and calibration value.

Remove the console

battery door with a coin

NOTE:

- The backup battery can back up: Time & Date, Max/Min records and calibration value.

- The built-in memory can back up: Router setting server settings.

POWER UP THE CONSOLE

1 . Plug in the power adapter to power up the console .

2 . Once the console is powered up, all the segments of the LCD will be shown .

3 . The console will automatically enter AP mode and sensor synchronization mode

automatically .

Blinking:

Sensor synchronization

process

4 . The wireless sensor will automatically pair up with the console (about 1 minute) .

Upon successful synchronisation, the display will change from "--.-°C --%" to actual reading.

NOTE:

If no display appears when powering up the console . You can press the [ RESET ] key by using a

pointed object. If this process still does not work, you can remove the backup battery and unplug the

adaptor then re-power up the console again .

RESET AND FACTORY HARD RESET

To reset the console and start again, press the [ RESET ] key once or remove the backup battery

and then unplug the adapter. To resume factory settings and remove all data, press and hold the

[ RESET ] key for 6 seconds .

CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR

Whenever you change the batteries of the wireless sensor, re-synchronization must be done

manually .

1 . Change all the batteries to new ones in the sensor .

2 . Press the [ SENSOR / WI-FI ] key on the console to enter sensor Synchronization mode.

3 . The console will re-register the sensor after its batteries are changed (about 1 minute) .

Step 1

Insert a new CR2032

Step 2

button cell battery

Step 3

Replace the battery door .

Flashing:

Console currently in Access

Point (AP) mode

Blinking:

Trying to connect to router

Stable:

Connected to router

Stable:

Connected to router and

synchronized to local time