Argo Nuk Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator Argo Nuk. Argo Nuk 13 stron. Local

Drukuj stronę

(6) TIMER BUTTON

a. When the air conditioner is off, press "TIMER" to set when to switch the unit on. Press "+" o "–" to set the time.

b. When the air conditioner is on, press "TIMER" to set when to switch the unit off. Press "+" o "–" to set the time.

Troubles

1. Unit does not start when pressing

power button

2. Not cool enough

3. Noisy

4. E0 Code

5. E2 Code

WARNING!

Prior to carrying out any cleaning or maintenance, unplug the unit from the power socket.

Cleaning the air filters

The air filter must be checked at least once every two weeks of operation. Operating with dirty or clogged filters will

decrease the effectiveness of the air conditioner and can cause serious problems.

To remove the filter, release the rear grille then slide out the filter by gently pulling it sideways.

Use a vacuum cleaner to remove any dust. Should this not

be sufficient, wash the filter with lukewarm water and

neutral detergent (if necessary), rinse it with cold water

then leave it to dry naturally before putting it back in place.

After putting the filter back in place, close the grille and

resume use of the air conditioner.

2. Cleaning the casing.

Use a soft damp cloth to clean the outer surface of the air conditioner.

Do not use excessively hot water, solvents, petrol or other aggressive chemical

compounds, talcum powder and brushes: they may damage the surface or

colour of the casing.

Remove any stains using warm water with a little neutral detergent.

Do not pour water onto the air conditioner to clean it: this may damage the

internal components or cause a short circuit.

3. Storage.

When you do not envisage using the air conditioner for a long time, clean the

filters before storing it away.

Keep the appliance in a vertical position at all times. Do not place any heavy objects on the

top and, if possible, protect the air conditioner with a plastic sheet.

V 01/18

TROUBLESHOOTING

Possible Causes

- Water full indicator lamp blinks, and

water tank is full.

- Room temperature is lower than the

setting temperature. (Cooling mode)

- There are heat sources inside the room.

- Exhaust air hose is not connected or

blocked.

- Temperature setting is too high.

- Air inlet is blocked.

- The ground is not levelled or not flat

enough

- The sound comes from the flowing of the

refrigerant inside the air conditioner

Room temperature sensor failed

Water tank full

CARE AND MAINTENANCE

Suggested Remedies

Dump the water out of the

water tank.

Reset the temperature

Remove the heat sources if

possible

Connect or clean the

exhaust air hose.

Reset the temperature

Clean the air inlet.

Place the unit on a flat, level

ground if possible

It is normal.

Replace room temperature

sensor (the unit can also

work without replacement.)

Please empty the water

tank.