Argo ORION PLUS Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator Argo ORION PLUS. Argo ORION PLUS 16 stron. Portable air conditioner (local)
Również dla Argo ORION PLUS: Instrukcja obsługi (18 strony)

Drukuj stronę

2. HEATING MODE (HEAT)

The "Heat" LED on the control panel will turn on.

 The temperature can be adjusted to between 16 °C and 32 °C.

 In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the temperature

setting and retains this setting when it is switched on again.

 In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.

 For more silent operation, run the fan at low speed.

3. DEHUMIDIFICATION MODE (DRY)



Press the MODE button to select the dehumidification mode.



The temperature is controlled by the electronic board and cannot be adjusted.



In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings and

retains them when it is switched on again.



The fan speed is set to low and cannot be adjusted.

NOTE

The air conditioner does not cool the room when operating as a dehumidifier.

When the appliance is used as a dehumidifier, the flexible pipe must not be connected.

For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly into the

environment.

The dehumidification mode is recommended during autumn and winter.

If used during summer, it is best to leave the flexible pipe attached so that the hot air is discharged

towards the outside rather than into the room.

During dehumidification, continuous drainage should be implemented (see the next chapter, "HOW TO ELIMINATE

CONDENSATE").

4. VENTILATION MODE (FAN ONLY)



Press the MODE button until the Fan icon appears.



In this mode, the fan speed can be adjusted.



The temperature cannot be adjusted.

This appliance automatically vaporizes the condensation in cooling.

When the air conditioner operates in Cooling, it is not necessary to have continuous condensate drainage; only in

particular climatic conditions in which the air humidity is very high, it can happen that water is deposited inside the unit.

In Heating the condensate is not vaporized automatically, it will therefore be necessary to empty the tank periodically.

Alternatively, drainage can be arranged from the lower hole on the back of the unit, the condensate drain will be

intermittent. When the internal tank is full, the air conditioner will emit 8 beeps and the display will show the

message "P1", signaling the filling and blocking the operation of the device.

V 01/21

HOW TO ELIMINATE CONDENSATE

Heating and Cooling

When the unit operates in the cooling and heating mode, ensure that the

rubber cap closing the drainage opening on the back of the appliance is

properly positioned.

To empty the container, switch the air conditioner off and unplug the cord.

Remove the cap from the rear drainage opening and place its end over a

normal drain. Ensure that the tube is not twisted or bent. The tube must slope

downwards. Re-close the drainage opening with the cap, insert it into the

clamp and resume use of the air conditioner.