Argo Polifermo Teddy Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator Argo Polifermo Teddy. Argo Polifermo Teddy 8 stron. Evaporative air cooler

IT'S NECESSARY TO FILL THE TANK WITH DEMINERALIZED WATER TO OPERATE THE

APPLIANCE IN COOLER/HUMIDIFIER MODE.

Water tank

opening

Counter-rotate the tank knob by 90° and remove it from its slot; fill it with demineralized water, up to the maximum level mark.

Reposition the tank and turn the knob.

If you wish to keep the water in the tank below room temperature in order to maximize cooling in warmer months, leave the

synthetic ice pack supplied in the freezer until solid, then add it to the water in the tank.

The ice will absorb heat from the water. We recommend continuous use of the ice for optimal

cooling capacity.

The first time it is used, you may detect a smell or the water may turn an unusual

colour: this does not constitute a health risk.

WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE

PROCEDURES.

IMPORTANT: DO NOT SUBMERGE THE PRODUCT IN WATER

Cleaning the outside surface of the appliance

Use a soft cloth to remove any dust from the product. If this is not enough, use a soft cloth dampened with water and a mild

detergent at a temperature not exceeding 50°C. Let the appliance dry completely before using it.

detergents or solvents such as petrol. Do not wash the appliance with water.

items that may damage the surface to clean it.

Cleaning the dust filter, the cooling panel and the tank

Clean the dust filter frequently, at least once a month.

Remove the dust filter by pulling the knob on the cooling panel, as indicated in the diagram below.

Panel Filter

V 01/18

FILLING THE WATER TANK

Fill the water tank with

demineralized water and/or ice

Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.

Clean the dust filter using a soft brush or a vacuum cleaner, and wash it in a solution of

water and mild detergent.

Remove the cooling panel at the same time and soak it in a solution of water and mild

detergent.

Take out the tank and and rinse it under running water, removing any residue.

Let the filter, the panel and the tank dry completely after washing them; then

components in the following order: water tank, cooling panel and dust filter.

Water level

indicator

Do not exceed the

maximum limit indicated

when filling the tank

Do not use corrosive

Do not use oils, chemical substances or other

re-fit the