Argo snappy Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator Argo snappy. Argo snappy 12 stron. Local air conditioner

INSTRUCTIONS TO REMOVE THE PACKAGING

FRONT VIEW - SIDE FOR COOLING, DEHUMIDIFYING MODES

REAR VIEW - SIDE FOR HEATING MODE

Operation limits: min/max. (indoor temperature):

Cooling: 17°C D.B. - 13°C W.B./ 32°C D.B. – 23° W.B.

Heating: 10°C D.B./32 °C D.B.

Dehumidify: 10°C D.B./32°C D.B.

The heating efficiency will fall off when the outdoor temperature

is very low. If enough heating is not obtained with this air

conditioner, use another heating appliance in conjunction with

it.

V 12/13

1. Place the unit in the correct upright position before unpacking.

2. Cut the two packing straps.

3. Slide the carton upwards and it will release the base.

4. Grip the carry handles located on either sides of the unit and carefully lift it until it slides out of

the foam base.

5. Lift and lean the unit slightly to take out exhaust hose from unit's bottom as in the picture.

6. Install the exhaust hose on the unit before operating the unit.

CONTROL PANEL - FUNCTION BUTTONS

FOR OPERATION WITHOUT REMOTE

CONTROL

REMOTE CONTROL RECEIVER

COOL AIR OUTLET (COOLING OPERATION)

CONNECTOR FOR COLD AIR EXPULSION

(12)

HOSE (HEATING OPERATION)

TERMINAL CONNECTOR FOR FLEXIBLE

HOSE

AIR EXPULSION TUBE

SIDE GRILL

CONDENSATE DRAIN HOLE (COOLING AND

HEATING OPERATION)

REMOTE CONTROL COMPARTMENT

10) CONNECTOR FOR HOT AIR EXPULSION

HOSE (COOLING AND HEATING

OPERATION)

11) HOT AIR OUTLET (HEATING OPERATION)

12) AIR FILTERS

13) SIDE GRILLES

14) CONDENSATE DRAIN HOLE

(DEHUMIDIFICATION)

15) CONCEALED WHEELS

16) REMOTE CONTROL

(16)