Cisco 6015 Uwagi dotyczące instalacji i wymiany - Strona 12
Przeglądaj online lub pobierz pdf Uwagi dotyczące instalacji i wymiany dla Sprzęt sieciowy Cisco 6015. Cisco 6015 18 stron. Dsl interface module fru
Również dla Cisco 6015: Skrócona instrukcja obsługi (38 strony)
Drukuj stronę
Removing and Installing the DSL Interface Module
Removing the DSL Interface Module
If you are using AC power and the power cord is plugged in to the wall outlet, unplug it.
Note
If you are using DC power and the fuses are already installed in the fuse and alarm panel, remove them.
You can replace the fuses after the system is installed and connected.
The fuse and alarm panel is not provided by Cisco.
Cisco recommends that you label each data cable at both ends to identify its destination.
Tip
Complete the following steps to remove the DSL interface module from the Cisco 6015 chassis:
Connect a grounding strap to the ESD grounding jack that is located on the fan module.
Step 1
Set the circuit breaker on the DC PEM to the OFF (0) position.
Step 2
Disconnect the two Champ connector cables from the front of the DSL interface module.
Step 3
Step 4
Use a flat-head or Phillips-head screwdriver to unscrew the four screws that hold the DSL interface
module to the Cisco 6015 chassis.
Hold the extraction handle on the front of the module and firmly pull the module out of the slot.
Step 5
See the
installation procedures.
Installing the DSL Interface Module
Note
If you are using AC power and the power cord is plugged in to the wall outlet, unplug it.
If you are using DC power and the fuses are already installed in the fuse and alarm panel, remove them.
You can replace the fuses after the system is installed and connected.
The fuse and alarm panel is not provided by Cisco.
Before installing or replacing the module, verify that the rack is securely stabilized.
Caution
Cisco recommends that you label each data cable at both ends to identify its destination.
Timesaver
Complete the following steps to install the DSL interface module in the Cisco 6015 chassis:
Connect a grounding strap to the ESD grounding jack that is located on the fan module.
Step 1
Removing the DSL Interface Module
12
"Installing the DSL Interface Module" section on page 12
for DSL interface module
OL-2186-01