Cisco 6015 Uwagi dotyczące instalacji i wymiany - Strona 9
Przeglądaj online lub pobierz pdf Uwagi dotyczące instalacji i wymiany dla Sprzęt sieciowy Cisco 6015. Cisco 6015 18 stron. Dsl interface module fru
Również dla Cisco 6015: Skrócona instrukcja obsługi (38 strony)
Drukuj stronę
This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260
Warning
Clause 1.2.14.3 Service Personnel.
Network hazardous voltages are present in the T1 PRI cable. If you detach the cable, detach the end
Warning
away from the router first to avoid possible electric shock. Network hazardous voltages are also
present in the area of the T1 PRI (RJ-48C) ports, regardless of whether power is off or on.
Warning
The telecommunications lines must be disconnected 1) before unplugging the main power connector
or 2) while the housing is open.
Warning
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Do not use a telephone to report a gas leak in the vicinity of the leak.
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning.
Hazardous network voltages are present in WAN ports regardless of whether power to the router is
Warning
OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching
cables, detach the end away from the router first.
To reduce the risk of electric shock when servicing any individual unit, disconnect the power cord or
Warning
cords that connect the unit to the AC power strip or DC busbar. When working with a DC system,
remove the busbar connector before working on a device. Exposed live voltages are present at the
device end; exposure to these may cause injury.
Warning
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool.
Warning
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
During line card installation, wear grounding wrist straps to avoid ESD damage to the card. Do not
Warning
directly touch the backplane with your hand or any metal tool, or you could shock yourself.
OL-2186-01
General Safety Precautions and Maintenance Guidelines
General Safety Precautions
9