Cisco 7513 Series Instrukcja wymiany - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Sprzęt sieciowy Cisco 7513 Series. Cisco 7513 Series 19 stron. Chassis replacement
Również dla Cisco 7513 Series: Skrócona instrukcja obsługi (44 strony), Instrukcja wymiany (26 strony), Arkusz danych (11 strony), Podręcznik (30 strony), Utrzymanie (20 strony), Instrukcja wymiany (22 strony)

Drukuj stronę

Tools Required

You need the following tools to install or replace backplane and card cage assembly:

•

A 1/4-inch ﬂat-blade screwdriver to loosen the captive screws on the power supplies and card

cage

•

You will need a number 1 Phillips or 1/4-inch ﬂat-blade screwdriver to remove any blank

processor module carriers (ﬁllers) and to tighten the captive installation screws that secure the

processor module in its slot.

•

Spare card cage assembly—includes the card cage with the chassis interface (attached) and dual

arbiter (attached)

•

ESD-preventive wrist strap.

•

Antistatic packaging in which the old card cage assembly should be placed

Removing Processor Modules

Replacing the card cage and backplane assembly ﬁrst requires you to remove all processor modules

installed in the card cage, and then replace them after the new card cage assembly is in place. The

term processor module refers to the RSP2 and all interface processors.

Note

is partially seated in the backplane will cause the system to hang and subsequently crash.

Timesaver

interface cables, use the port and slot worksheet in Table 1 to note which cables are connected to

which interface processor ports. (Also refer to Figure 10.)

Timesaver

processor modules and both power supplies. Plan this procedure so that you can minimize its effects

on your system.

To remove a processor module, follow these steps:

Step 1

Step 2

Step 3

Step 4

Step 5

Always use the ejector levers when installing or removing processor modules. A module that

To save time when you reinstall the processor modules in the card cage and reconnect

Before you can remove the card cage and backplane assembly, you must remove all

Turn OFF power to the chassis. If two power supplies are installed, the power switch on

each supply must be in the OFF (O) position.

Attach an ESD-preventive strap between you and an unpainted surface on the chassis.

If there is not enough slack in the network interface cables to remove the processor module

without straining the cables, disconnect any cables attached to the interface ports.

You must pull each processor modules straight out of its slot. Ensure that there are no

obstructions that will prevent you from doing so, such as a power strip on a rack post,

network connection devices attached to adjacent processor modules, or extensive cabling

in front of the processor slots.

Use a screwdriver to loosen the captive installation screws at the both ends of the processor

module. (See Figure 3a.)

Cisco 7513 Card Cage and Backplane Assembly Replacement Instructions

Removing Processor Modules