Argo ACD 410 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Niszczarka do papieru Argo ACD 410. Argo ACD 410 16 stron.

Drukuj stronę
ELECTRICAL
•
The machine should be plugged to the electric circuit only as presented in the manual.
•
The socket must be in close vicinity with easy access to the device. While moving the
machine, pull the plug from the socket.
•
To turn off the appliance unplug it from the socket. Socket should be in close vicinity
with easy access to device.
•
Do not use the machine when the wire or plug are damaged or after noticing symptoms
of machine's damage. Please contact seller to obtain help.
•
When the device is equipped with a plug with grounding, then it has to be connected
to a socket with grounding!
SERVICE
Proceed only with routine actions according to the manual. Do not repair or service
machines on your own. Unplug the machine from the circuit and contact seller when one
or more of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual

PROBLEM SOLVING

problems
No operation
No operation after
long time operation
Stop at shredding
© ARGO S.A.
EN
checklists
The power plug is properly
inserted to main supply?
Switch is set at „I" position?
Switch at „l" position but power
light off.
No operation when insert paper?
Checked above but no operation
and no power light.
Power lamp is on?
Machine is continuously
shredding for a long time?
14
solutions
Fully put the power plug to the
outlet.
Set switch to „I" position for
operation.
Check basket is out of stand.Put
basket back to stand.
Paper should be inserted to
trigger the sensor at center.
Send back to your local service
for repair.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
www.argo.pl