Cisco Aironet 1140 Series Podręcznik dla początkujących - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Sprzęt sieciowy Cisco Aironet 1140 Series. Cisco Aironet 1140 Series 31 stron. Autonomous access point
Również dla Cisco Aironet 1140 Series: Podręcznik dla początkujących (35 strony), Podręcznik konfiguracji (40 strony), Arkusz danych (6 strony), Podręcznik dla początkujących (37 strony)

22/09/2019

Note You can mount the access point above a suspended ceiling but you must purchase

additional mounting hardware: See the

information.

•

Access point power options: power supplied by a DC power supply, PoE from a network device,

or a PoE power injector/hub (usually located in a wiring closet).

Note Access points mounted in a building's environmental airspace must be powered using PoE

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can

record the device MAC addresses from each location and return them to the person who is

planning or managing your wireless network.

4 Obtaining and Assigning an IP Address

To browse to the access point Express Setup page, you must either obtain or assign the access

point IP address using one of these methods:

Note The access point does not have a default IP address.

•

Assign a static IP address by connecting to its console port and accessing the access point CLI.

•

Use a DHCP server (if available) to automatically assign an IP address. You can nd out the

DHCP-assigned IP address by using one of the following methods:

–

Connect to the access point console port and use a Cisco IOS command to display the IP

address, such as show interface bvi1.

–

Provide your organization's network administrator with your access point MAC address. Your

network administrator will query the DHCP server using the MAC address to identify the IP

address. The MAC address is on a label attached to the bottom of the access point.

–

Use the CLI and serial port to identify the assigned IP address.

If you need to con gure the access point locally (without connecting it to a wired LAN), you can

connect a PC to its console port by using a DB-9 to RJ-45 serial cable.

Caution Be careful when handling the access point, the bottom plate might be hot.

Follow these steps to open the CLI by connecting to the access point console port:

Step 1 Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 console port on the

access point and to the COM port on a computer.

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html

Getting Started Guide: Cisco Aironet 1140 Series Autonomous Access Point - Cisco

"Mounting the Access Point" section

for additional

6/30