Argo Wallner HD-208 C2 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Niszczarka do papieru Argo Wallner HD-208 C2. Argo Wallner HD-208 C2 15 stron.

Drukuj stronę

PROBLEM SOLVING

problems

No operation

No operation after

long time operation

Excess squeaking

and rubbing noise

Overload

MALFUNTION / MAINTENANCE

If any faults should appear, please pass the machine along with the warranty card to the

seller or closest authorised dealer. The machine might be passed futher, thus the user

should maintain the original and complete packaging. In cases when the machine is

passed for repair in a not original or incomplete package, the risks of futher damages that

might arise in transportation are on the user's side. Thus, in such a case, it is in the user's

best interest to make the best possible replacement packaging.

NOTE ON ENVIRONMENTAL PROTECTION

After the implementation of the European Directive 2002/96/EU in the national

legal system, the following applies: Electrical and electronic devices may not be

disposed of with domestic waste.

Consumers are obliged by law to return electrical and electronic devices at the

end of their service lives to the public collecting points set up for this purpose or

point of sale. Details to this are defined by the national law of the respective country. This

symbol on the product, the instruction manual or the package indicates that a product is

subject to these regulations. By recycling, reusing the materials or other forms of utilising

old devices, you are making an important contribution to protecting our environment.

checklists

The power plug is properly

inserted to main supply?

Switch is set at „I" position?

No operation when insert paper?

Checked above but no operation

and no power light.

Overheat light is on?

Without oiling to the cutting

system periodically.

- Squeaking and rubbing noise at

shredding.

- Exceeding the shredding

capacity

- The paper is not fed squarely

into the feed opening.

solutions

Fully put the power plug to the

outlet.

Press the Power button

Paper should be inserted to

trigger the sensor at center.

Send back to your local service

for repair.

Unplug the machine from

main supply. Allow to cool

down to room temperature

and resuming operation.

Perform the cutter oiling

instruction to lubricate the

cutting system.

Set switch to „R" for reverse

running and frees excess

paper. Then set to „I" for cutting

the remainder of paper left in

the cutting system. If serious

jim occurred, send back to

local service for repair.