Argo Wallner HD-300 C2 Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Niszczarka do papieru Argo Wallner HD-300 C2. Argo Wallner HD-300 C2 16 stron.
Drukuj stronę
•
Unstable surfaces may cause the fall of the device, which can result in body injuries.
•
Please avoid fast stopping, use of additional force or surface unevenness while
transporting the device on trolley, casters or table.
•
Do not remove mechanical and electrical securities such as locks, covers or others.
It is forbidden to use objects not dedicated to do so or liquids.
ELECTRICAL
•
The machine should be plugged to the electric circuit only as presented in the manual.
•
The socket must be in close vicinity with easy access to the device. While moving the
machine, pull the plug from the socket.
•
To turn off the appliance unplug it from the socket. Socket should be in close vicinity
with easy access to device.
•
Do not use the machine when the wire or plug are damaged or after noticing symptoms
of machine's damage. Please contact seller to obtain help.
•
When the device is equipped with a plug with grounding, then it has to be connected
to a socket with grounding!
SERVICE
Proceed only with routine actions according to the manual. Do not repair or service
machines on your own. Unplug the machine from the circuit and contact seller when one
or more of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual
PROBLEM SOLVING
problems
No operation
No operation after
long time operation
Excess squeaking
and rubbing noise
© ARGO S.A.
EN
checklists
The power plug is properly
inserted to main supply?
Switch is set at „I" position?
No operation when insert paper?
Checked above but no operation
and no power light.
Overheat light is on?
Without oiling to the cutting
system periodically.
- Squeaking and rubbing noise at
shredding.
14
solutions
Fully put the power plug to the
outlet.
Press the Power button
Paper should be inserted to
trigger the sensor at center.
Send back to your local service
for repair.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Perform the cutter oiling
instruction to lubricate the
cutting system.
www.argo.pl