Cisco Aironet 1430 Series Podręcznik dla początkujących - Strona 29

Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Sprzęt sieciowy Cisco Aironet 1430 Series. Cisco Aironet 1430 Series 48 stron. Wireless bridge

Drukuj stronę
Table 8
Power Injector LED Indications (continued)
Uplink Activity
Injector Status
—
Blinking Amber —–
Amber
Amber
Off
Amber
—
Red
Red
Red
Checking Power
You can verify the availability of power to the bridge by checking the power injector LEDs (see
Figure 8):
• Power LED
Green color indicates 48 VDC is available to the power injector (see Figure 8).
–
Off indicates 48 VDC is not available to the power injector—verify that the power module is
–
connected to the power injector and to an AC receptacle and that AC power is available.
• Uplink Activity LED
Green or blinking green color indicates the bridge is operating.
–
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Ethernet Activity Description
Amber
Off
—
Red
Bridge has not been detected and bridge power
is not active. This might be caused by bad
connections or a defective cable or connector.
Verify that the dual-coax cables are connected
correctly to the power injector, grounding
block, and bridge. If the cables are connected
correctly, contact technical support for
assistance.
Power injector internal memory
error—disconnect and reconnect the power
injector power plug. If the problem continues,
contact technical support for assistance.
Bridge is resetting the configuration to
defaults; mode button has been depressed
more than 2 seconds but less than 20 seconds.
Image recovery mode, downloading new
image; mode button pressed more than 20
seconds.
Power injector internal memory
error—disconnect and reconnect the power
injector power plug. If the problem continues,
contact technical support for assistance.
29