Sony PMW-100 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Aparat cyfrowy Sony PMW-100. Sony PMW-100 31 stron. Solid-state memory camcorder
Również dla Sony PMW-100: Broszura i specyfikacje (8 strony), Broszura i specyfikacje (6 strony), Pierwsze kroki (2 strony), Instrukcja obsługi (32 strony)

Drukuj stronę

Preparations

Power Supply

You can use a battery pack or AC power via an

AC adaptor.

For safety, use only the Sony battery packs and

AC adaptor listed below:

Lithium-ion Battery Pack

BP-U30

BP-U60

BP-U90

Battery Charger/AC Adaptor

BC-U1

BC-U2

WARNING

Batteries shall not be exposed to excessive heat

such as sunshine, fire or the like.

AVERTISSEMENT

N'exposez pas les batteries à une chaleur

excessive, au soleil ou près d'un feu par exemple.

WARNUNG

Akkus dürfen keinesfalls übermäßiger

Wärmeeinwirkung ausgesetzt werden, wie z.B.

Sonneneinstrahlung, Feuer o. ä.

Note

The AC adaptor cannot be connected to the camcorder

while the battery pack is inserted.

Using a Battery Pack

Fully insert the battery pack into the battery pack

receptacle (page 8), then slide it to the left to lock

it.

To remove the battery pack, press and hold the

BATT RELEASE button (page 8), slide the

battery pack upward to unlock it, then pull it out.

Notes

• Before use, charge the battery pack with the supplied

BC-U1 or BC-U2 Battery Charger.

• A warm battery pack immediately after use may not be

able to be fully recharged.

• The high-capacity BP-U90 Battery Pack is large, and

protrudes from the camcorder when attached. When

using the camcorder with the BP-U90 attached for

extended recording periods, Sony recommends

attaching the camcorder to a tripod for convenience.

Power Supply

Checking battery charge remaining

When recording or playback is in progress on the

battery pack, an icon to show the current battery

charge level and usage time remaining are

displayed on the LCD monitor/viewfinder screen

("Preparations" in operating instructions (PDF)).

Icon

Remaining

100% to 91%

90% to 71%

70% to 51%

50% to 31%

30% to 11%

10% to 0%

The camcorder indicates the remaining usage

time in minutes by calculating the available time

with the battery pack if operation is continued at

the current rate of power consumption.

If the battery charge remaining becomes

low

If the battery charge remaining decreases to a

certain level during operation (Low BATT

status), a low-battery message, flashing of the

tally lamps, and a beep sound will warn you.

If the remaining further decreases to a level at

which operation cannot be continued (BATT

Empty status), a battery-empty message appears.

Replace the battery pack with one that is fully

charged.

To change the message levels

The Low BATT level is set to 10% of full charge,

and the BATT Empty level is set to 3% of full

charge at the factory. These settings can be

changed with "Battery Alarm" ("Menu

Configuration and Detailed Settings" in operating

instructions (PDF)) in the OTHERS menu.