Sony PMW-100 Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Aparat cyfrowy Sony PMW-100. Sony PMW-100 31 stron. Solid-state memory camcorder
Również dla Sony PMW-100: Broszura i specyfikacje (8 strony), Broszura i specyfikacje (6 strony), Pierwsze kroki (2 strony), Instrukcja obsługi (32 strony)

Drukuj stronę

Switching Between SxS Memory

Cards

When SxS memory cards are loaded in both card

slots A and B, press the SLOT SELECT button

(page 10) to select the card you wish to use.

If a card becomes full during recording, switching

to the other card is automatically executed.

Note

The SLOT SELECT button is disabled while playback is

in progress. Switching is not executed even if you press

the button. The button is enabled while the thumbnail

screen is displayed ("Playback" in operating instructions

(PDF)).

Formatting an SxS Memory Card

For an SxS memory card that is not formatted or

that was formatted with another system, the

message "Unsupported File System" is displayed

on the LCD monitor/EVF screen.

Format the card as instructed in "To execute

formatting" below.

To execute formatting

Using "Format Media" ("Menu

Configuration and Detailed Settings" in

operating instructions (PDF)) in the

OTHERS menu, specify "Media(A)" (slot

A) or "Media(B)" (slot B) then select

"Execute." On a confirmation message,

select "Execute" again.

The in-progress message and status bar (%) are

displayed, and the ACCESS lamp lights in red.

When formatting is completed, the completion

message is displayed for three seconds.

Recording/playback during formatting

You can perform recording or playback using the

SxS memory card in the other card slot while

formatting is in progress.

If formatting fails

A write-protected SxS memory card or memory

card that cannot be used with this camcorder will

not be formatted.

As a warning message is displayed, replace the

card with an appropriate SxS memory card, as per

the instructions in the message.

Note

All the data, including recorded pictures and setup files,

are erased when a memory card is formatted.

Checking the Remaining Time

Available for Recording

While recording (or standing by to record), you

can check the time remaining for the SxS memory

cards loaded in the card slots on the LCD

monitor/EVF screen ("Preparations" in operating

instructions (PDF)).

The available time for recording with the current

video format (recording bit rate) is calculated

according to the remaining space of each card and

displayed in time units of minutes.

The remaining can also be checked in a meter

format on the Battery/Media status screen

("Status Displays" in operating instructions

(PDF)).

Note

icon appears if the memory card is write-

protected.

Replacing an SxS memory card

• If the available time on two cards in total

becomes less than 5 minutes, a message "Media

Near Full," flashing of the tally lamps, and a

beep sound will warn you. Replace the cards

with those with sufficient space.

• If you continue recording until the total

remaining time reaches zero, the message

changes to "Media Full," and recording stops.

Note

Approximately 600 clips can be recorded on one SxS

memory card at maximum.

If the number of recorded clips reaches the limit, the

remaining time indication becomes "0," and the message

"Media Full" is displayed.

Restoring an SxS Memory Card

If an error occurs with data in a memory card for

some reason, the card must be restored.

If an SxS memory card that needs to be restored

is loaded, a message that prompts you to execute

a restore operation is displayed on the LCD

monitor/EVF screen.

Using SxS Memory Cards