Cisco Aironet 340 Series Informacje o wersji - Strona 10

Przeglądaj online lub pobierz pdf Informacje o wersji dla Sprzęt sieciowy Cisco Aironet 340 Series. Cisco Aironet 340 Series 14 stron. Usb client adapter
Również dla Cisco Aironet 340 Series: Skrócona instrukcja obsługi (12 strony), Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (16 strony), Skrócona instrukcja obsługi (12 strony), Skrócona instrukcja obsługi (12 strony)

Troubleshooting

•

Resolved Caveat

The following caveat is resolved in version 12.01T1:

•

Troubleshooting

For the most up-to-date, detailed troubleshooting information, refer to the Cisco TAC website at

http://www.cisco.com/tac. In the Tools and Utilities section, Select Wireless Troubleshooting Center.

The Wireless Troubleshooting Center page appears. Choose the link that best suits your troubleshooting

needs.

Release Notes for Cisco Aironet 340 and 350 Series Access Points and 350 Series Bridges Running Firmware Version 12.01T1

CSCdy27831—When you set the default Unicast Address Filter to disallowed, you must reboot the

access point for the setting to take effect.

CSCdy73695—When a repeater access point receives packets from a root access point while the

repeater is attempting to associate, the repeater sometimes displays this error:

00:00:10 (Warning): Station <Root MAC address> Associated with Encryption, then

attempted to send an Unencrypted packet to <Repeater MAC address> (length 74)

The error occurs when WEP is not enabled on either the root or the repeater. When an association

response is received by the repeater, it no longer displays the error message and is able to

successfully pass data. However, if a significant amount of traffic, such as multicast traffic, is being

transmitted by the root access point while the repeater is attempting to associate, the repeater may

miss the association response from the root access point and never fully associate. In this case, the

root access point reports that the repeater is associated and the repeater reports that it is only

authenticated. The repeater continues to display warning messages about receiving unencrypted

packets and does not recover until it is rebooted.

CSCdx81372—Access point does not accept version 11.56-generated .ini file

If you download the full configuration .ini from an access point running 11.56, upgrade to version

12.01T1, and then attempt to download the .ini file from an FTP server, the following error message

appears:

*** No Such MIB Variable as Specified on Initialization File Line xxx! for the

following variables:

awcAaaServerAccountingEnabled.x,

awcVoIPVlanId, awcVoIPVlanEnabled,

awcPublicVlanId.

*** Bad Value for MIB Variable awcVlanEncapMode Specified on Initialization File Line

xxx (error 13)!

Workaround—When producing .ini files, dump a non-default configuration for version 11.56

instead of a full configuration.

CSCdz58192—Root bridges with LEAP enabled on the native VLAN must have the security setting

matching that set on the Advanced Radio Setup page. If the settings do not match, the bridge link

will go down temporarily whenever an infrastructure device authenticates.

CSCdz66748 (CSCdz60229)—Access points are no longer vulnerable to a denial of service (DoS)

when support for the Secure Shell (SSH) server is enabled. Malformed SSH packets directed at the

access point no longer cause a reload of the device.

OL-3740-01