Sony CECH-ZVS1A Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony CECH-ZVS1A. Sony CECH-ZVS1A 20 stron. Surround sound systems

Drukuj stronę

Additional Information

Troubleshooting

Go through this section if you experience

difficulty in operating the system. Also visit

http://eu.playstation.com/help-support. Should

any problem persist, contact SCEE Consumer

Services (back cover) for assistance.

POWER

The power is not turned on.

• Check that the AC adaptor and the AC power

cord are connected securely.

The system is turned off automatically.

• The auto standby function is working

(page 16).

SOUND

Dolby Digital or DTS multi-channel audio is not

reproduced.

• Check that the Blu-ray Disc, DVD, etc., is

recorded in Dolby Digital or DTS format.

• Check that [Audio Output Settings] under

(Settings)

PS3™ system are set correctly (page 12).

The surround effect cannot be produced.

• Depending on the digital signal, the surround

processing may not work (page 13).

Audio lags video.

• Set "SYNC" to "OFF" if "SYNC" is set to

"ON."

No sound or only a very low-level sound of the

PS3™ system is heard from the system.

• Press the VOL + button and check the

volume level.

• Press the MUTING button or the VOL +

button to cancel the muting function.

• Check that the input source is correctly

selected.

• Check that the cable connecting the system

and the PS3™ system is fully inserted.

(Sound Settings) on the

Sound is interrupted or there is noise.

• Check "Digital input formats supported by

this system" (page 18).

The remote control does not

function

• Point the remote control at the IR receiver

on the surround sound system.

• Remove any obstacles in the path between

the remote control and the system.

• Replace the battery in the remote control

with a new one, if it is weak.

• Make sure you select the correct input on the

remote control.

OTHER

"PROTECT" appears in the display

• Press the power button to turn off the power.

After "STANDBY" disappears, make sure

that the ventilation slots are not blocked.

If the surround sound system still

does not operate properly after

performing the above measures

• Reset the system by following the procedure

below.

Press the power button to turn on the

power.

Press the power button while pressing

the INPUT button and the VOL – button.

"RESET" appears and the system is reset.

Menu, sound field, etc., return to the default

settings.