Sony CMT HPZ7 Instrukcja obsługi - Strona 32
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony CMT HPZ7. Sony CMT HPZ7 40 stron. Micro hi-fi component system
Również dla Sony CMT HPZ7: Instrukcja obsługi (40 strony), Instrukcja obsługi (40 strony)

Tuner
Severe
hum or noise/stations
cannot
be
received.
• Set the proper band and frequency
(page
18)
• Connect the antenna properly
(page 10)
• Find a place and an orientation
that provide good
reception
then set up the antenna
again
If you
cannot obtain good reception
we recommend
you
connect
a commercially
avaih,ble
external
antenniL
• The supplied
PM lead antenna
receives
signals
along its entire length
so make sure you extend it
fillly
• Locate the antennas
as l.lr ax_ay from the speaker
cords as possible
• Consuh your nearest Sony dealer
if the supplied
AM antenna
has come off the plastic
stand
• Try turning
off surrounding
electrical
equipment
• Set "CD POWER"
and "OFF" by' CD power
manage
function
(page 19)
A stereo
FM program
cannot
be received
in
stereo.
• Press FM MODE
until 'STEREO
appears
in the
disphly.
Tape
deck
The tape does not record
or play, or there is a
decrease
in sound level.
• The heads are dirty. Clean them (page 35).
• The record/phlyback
heads are magnetized.
Demagnetize
them (page 35).
The tape does not erase
completely.
• The record/ph,yback
heads are magnetized.
Demagnetize
them (page 35).
There is excessive
wow or flutter,
or the sound
drops
out.
• The capstans
in the tape deck are dirty. Clean
them (page 35).
Noise
increases
or the high frequencies
are
erased.
• The record/ph,yback
heads are magnetized.
Demagnetize
them (page 35).
The tape does not record.
• No cassette
is loaded. Load a cassette.
• The tab has been removed
from the cassette.
Cover the broken
tab with adhesive
tape
(page 35).
• The tape has wound to the end.
Optional
components
There is no sound.
• Refer to General item "There is no sound."
(page 30) and check the condition of the system.
• Connect the component properly (page 28) while
checking:
if the cords are connected properly.
if Ihe cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied x_ith
the connected component and start phlying.
• Press FUNCTION repeatedly to select "MD"
(page 29).
The sound is distorted.
•
Set the volume of the connected
component
lower.
If the
system
still
does
not
operate
properly
after
performing
the
above
measures,
reset
the
system
as follows:
Use buttons on the unit _r the operation.
1
Disconnect the power cord.
2 Reconnect the power cord.
3 Press I/(_) to turn on the system.
4
Press I,
ILLUMINATION
and I/(_.
The system is reset to the factory settings. Ynu
should set the settings you made. such as the
preset stations, clock, attd timer.
32G8