Sony CMT-BX3R Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony CMT-BX3R. Sony CMT-BX3R 32 stron. Sony operating instructions micro hi-fi component system cmt-bx4r, cmt-bx3r
Drukuj stronęNotes
Do not remove the USB device during
recording or erase operations. Doing so
may corrupt the data on the USB device or
damage the USB device itself.
Do not connect the system and the USB
device through an USB hub.
When recording from a CD, the tracks
are recorded as 128 kbps MP3 files. When
recording from an MP3 disc, MP3 files
are recorded with the same bit rate as the
original MP3 files.
While recording from an MP3 disc, no sound
is output and "HI-SPEED" appears.
CD text information is not recorded in the
created MP3 files.
If you cancel the recording partway, an
MP3 file is created up to the point when the
recording was stopped.
Recording stops automatically if:
the USB device runs out of space during
recording.
the number of MP3 files on the USB
device reaches the limit for the number
that the system can recognize.
The maximum number of MP3 files and
folders that can be contained on a single USB
device is 999 (including the "ROOT" and
"MUSIC" folders).
The maximum number of MP3 files and
folders may vary depending on the MP3 file
and folder structure.
You cannot erase MP3 files and folders in
shuffle play mode or program play mode.
If the folder to be erased contains non-MP3
format files or sub folders, these are not
erased.
If a folder or file that you are trying to record
already exists on the USB device with the
same name, a sequential number is added
after the name without overwriting the
original folder or file.
1
GB
Listening to music of
an USB device
You can listen to music stored in the USB
device.
The audio format that can be played back
by this system is MP3* only.
See "Playable/Recordable USB devices"
(page 31) for a list of USB devices that
can be connected to this system.
*
Files with copyright protection (Digital
Rights Management) cannot be played by
this system.
1
Select the USB function.
Press USB
.
2
Connect an optional USB device
to the
(USB) port
unit.
When the USB device is connected,
the display changes as follows:
"READING" "STORAGE
DRIVE*"
* When connecting USB storage media,
the volume label is displayed next if
recorded.
Note
It may take about 10 seconds before
"READING" appears depending on the
type of USB device connected.
3
Start playback.
Press (or USB on the unit)
.
4
Adjust the volume.
Press VOLUME +/ (or VOL +/ on
the unit)
.
on the