Cisco ASA 5506-X Montaż i połączenie - Strona 2

Przeglądaj online lub pobierz pdf Montaż i połączenie dla Sprzęt sieciowy Cisco ASA 5506-X. Cisco ASA 5506-X 12 stron. Threat defense reimage guide
Również dla Cisco ASA 5506-X: Skrócona instrukcja obsługi (10 strony), Skrócona instrukcja obsługi (14 strony), Instrukcja łatwej konfiguracji (11 strony), Instrukcja oprogramowania (37 strony), Instrukcja instalacji (46 strony), Montaż obudowy (10 strony), Instrukcja instalacji sprzętu (26 strony)

Wall Mount the ASA

Follow these steps to mount your ASA on a wall. You can purchase a wall mount kit. The part number for

the wall mount kit is ASA5506-WALL-MNT= .

Step 1

Choose a location on the desired wall for the ASA.

Step 2

Use the two Cisco-provided screws and anchors from the optional wall-mount kit.

If you are mounting the ASA onto something other than drywall, such as wood or sheet metal, anchors may not be

required.

Step 3

Use a pencil, ruler, and level to mark locations for the two mounting screws.

The width and length of the ASA are 7.87 x 9.23 inches ( 20 x 23.44 cm). The mounting holes in the chassis are in the

middle length-wise (that is, 6.372 inches from front and back), while the holes are inset from the opposite edges 0.75

inches (1.9 cm).

Thus, you need to make two level marks 6.37, or approximately 6-3/8, inches (16.18 cm) apart.

Figure 1: Marking the Locations of the Two Mounting Screws

Step 4

Drill a hole into the wall at each mark.

These holes should be slightly smaller in diameter than your anchors. The recommended drill hole size is 3/16".

Step 5

Insert the anchors into the holes and be sure they are properly seated.

Step 6

Fasten each screw into its anchor until it protrudes about 1/4 inch.

Step 7

Pick up the ASA, align the screws in the anchors with the holes in the bottom of the chassis, move the ASA toward the

wall until the screw heads are in the chassis, and then slide the ASA down until it rests on the screws.

Mount and Connect