Argo SKY 350 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Laminator Argo SKY 350. Argo SKY 350 12 stron.

- Open the Cold film and position the item to be laminated so its backside is against the non-

sticky side of the film (Set the speed „2" manually in order to perform this lamination).

- And then laminating.

Cold Laminating at Initial Stage - Lamination must be performed under temp, of 30°C.

How to Use (Hot)

Hot laminating is used to perform lamination of photographs. i.D cards, various publica-

tion documents and others with heat. Depending on the time and the original temperature

& speed should be adjusted properly.

- turn on the power switch and select HOt mode (temp 100°C, speed 0 is automatically

set, and when the temp of roller reaches above 80°C, the speed becomes 4 and the

roller start to roll.)

- When the ready lamp starts to blink, user can start to perform laminating.

Getting Ready for Lamination

- Place original into the sealed laminating pouch film. (the pouch film should be at least

3mm bigger all around than the original inserted. if the margin is wider, both ends of

pouch can be folded during lamination.)

- Beginning Lamination

(if user wishes to laminate faster: it can be adjusted manualy for quicker lamination. And

when adhesion of lamination is not satisfactory, increase the temperature by operating

temperature control key.)

- Finishing up Lamination

Press „COLD" key: Upon finishing the lamination, „COLD" key can be pressed to turn off

the machine. temperature „0" speed „2" will be displayed on LCD temperature will start

to decrease, and once it reaches 80°C the rollers stop automatically.

in order to extend the lifetime of the rollers, select „COLD" mode first, then turn off

the power switch when the temperature is below 80°C

cleaninG tHe roller

Lettering the laminator cool down

Cleaning rollers: Sprinkle small pro-

per amount of alcohol on a clean

non-lining cloth and wipe the rollers

off carefully. Change the position of

the rollers with the Speed 1 and OFF. Let the alcohol soak in for a while on stubborn resi-

dues of adhesive or film and then remove them by wiping with a clean cloth.

Never use a pointed or sharp-edge instrument such as knives or screw drivers to

clean the rollers.

Nasza oferta w internecie: www.argo.pl