Argo WALLNER DWL-4CF Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Laminator Argo WALLNER DWL-4CF. Argo WALLNER DWL-4CF 12 stron. Laminating machine

Drukuj stronę
LAMINATING MACHINE
WALLNER DWL–4CF / DWL-3AF
Read all instructions before use.

PART NAMES

MAIN SWITCH (4)

After pressing the main switch placed on the side of the laminating machine to the „I"
position, the rollers begin to roll. The „POWER" light (1) will lighten up.
READY LIGHT (2)
The light informs:
o ff - that the temperature of the rollers is below the set temperature,
o n - that the temperature of the rollers is equal or higher then the set temperature.
To stabilize the temperatures and obtain best laminating results it is
WARNING!
advisable to wait additional 5-10 minutes after the READY light lightens up.
RELEASE/REVERSE BUTTON (6)
In case the pouch is not fed vertically into the entrance or jammed inside, push the jam
release button (6), then the pouch can be easily pulled out of the entrance.
TEMPERATURE REGULATOR (4)
Allows to adjust the laminating temperature accordingly to the used pouch's thickness.
The regulator shows values in microns, as on laminating pouches, to allow easy setting
of adequate temperatures.
© ARGO S.A.
EN
1.
POWER LIGHT
2.
READY LIGHT
3.
TEMPERATURE REGULATOR
4.
MAIN SWITCH (I/O)
5.
ENTRY
6.
RELEASE/REVERSE
BUTTON
7
www.argo.pl