Argo Wallner LM341 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Laminator Argo Wallner LM341. Argo Wallner LM341 9 stron. Laminating machine

Drukuj stronę
LAMINATINg MACHINE WALLNER LM341 / LM441
Read all instructions before use.

PART NAMEs

6
OPERATION INsTRUCTION
HOT LAMINATION
1.
Before laminating it is advisable to carry out a test lamination to familiarise yourself
with the machine and to make sure that it is working correctly.
2.
Plug the machine into an appropriate and easy-to-reach socket.
3.
Set the main switch (4) placed on the side of the laminating machine in the „I" position.
4.
Press the MODE BUTTON to select the pouch thickness. The correspondent LED
would turn into red and flash.
5.
The machine is ready to use when the LED light turns to green and stays steady.
6.
Insert the document with the sealed side first into the entry (5).
7.
The laminating process is finished when the whole document comes out from the
other end of the machine.
8.
If the document is not properly laminated, repeat steps 6 and 7.
9.
If the pouch gets jammed inside, push the REVERSE BUTTON (6).
10.
If you are not using the machine, turn it off. This will guarantee best laminating results
each time.
CAUsION!
It is important to use the pouch similar to the size of the laminating document.
Documents need to be inserted into the laminating pouch squarely and centrally,
with a margin of around 3 mm from each side. A wider margin may cause folding,
bending or blocking of the laminated document.
© ARGO S.A.
EN
1
3
2
4
5
1. POWER/COLD LIGHT
2. LED LIGHTS
3. MODE BUTTON - POUCH THICKNESS REGULATOR
4. MAIN SWITCH (I/O)
5. ENTRY
6. REVERSE BUTTON
6
www.argo.pl