Sony MHC-V3 Instrukcja obsługi - Strona 29
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony MHC-V3. Sony MHC-V3 36 stron.
Drukuj stronę
Tuner
There is severe hum or noise, or
stations cannot be received. ("ST"
flashes in the display panel.)
• Connect the antenna properly.
• Change the antenna location and its
orientation to obtain good reception.
• Connect a commercially available
external antenna.
• Turn off surrounding electrical
equipment.
Bluetooth device
Pairing cannot be performed.
• Move the Bluetooth device closer to the
system.
• Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn off the other
Bluetooth devices.
• Make sure the correct passkey was
entered at the Bluetooth device.
The Bluetooth device cannot detect
this unit, or "BT OFF" appears in the
display panel.
• Set the Bluetooth signal to "BT ON"
(page 20).
Connection is not possible.
• The Bluetooth device you attempted to
connect does not support the A2DP
profile, and cannot be connected with
the system.
• Enable the Bluetooth function of the
Bluetooth device.
• Establish a connection from the
Bluetooth device.
• The pairing registration information has
been erased. Perform the pairing
operation again.
• Erase the pairing registration
information of the Bluetooth device
(page 19) and perform the pairing
operation again (page 18).
The sound skips or fluctuates, or the
connection is lost.
• The system and the Bluetooth device are
too far apart.
• If there are obstacles between the
system and your Bluetooth device,
remove or avoid the obstacles.
• If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device,
or a microwave oven nearby, move
them away.
The sound of your Bluetooth device
cannot be heard on this system.
• Increase the volume on your Bluetooth
device first, then adjust the volume
using VOLUME +/–.
There is severe hum, noise or
distorted sound.
• If there are obstacles between the
system and your Bluetooth device,
remove or avoid the obstacles.
• If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device,
or a microwave oven nearby, move
them away.
• Turn down the volume of the connected
Bluetooth device.
To reset the system
If the system still does not operate
properly, reset the system to factory
default settings.
Use the buttons on the unit to perform this
operation.
1
Unplug and plug the AC power cord
back in.
2
Press "/1 to turn on the system.
3
Hold down x and ENTER for about
3 seconds.
"RESET" appears in the display panel.
All user-configured settings, such as
preset radio stations, timers, and the
clock are reset to factory default
setting.
29
GB