Sony SA-VE702 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony SA-VE702. Sony SA-VE702 28 stron. Micro satellite system
Również dla Sony SA-VE702: Instrukcja obsługi (15 strony)
Drukuj stronę
3
Using the supplied hex wrench, two
screws, and washers, secure the
speaker to the stand.
Notes
• Do not remove the supplied speaker grille from
the speaker while attaching the speaker to the
speaker stand.
• Do not touch or press tweeter's cover on the center
of the speaker.
4
Adjust the angle of the speaker
stand.
Loosen the two screws under the base to
adjust the angle. Then tighten them
again afterwards.
15º
25º
The optional speaker
stands
For greater flexibility in the positioning of the
speakers, use the optional WS-FV10 (floor
stand), WS-TV10 (TV stand), or WS-WV10
(wall mount bracket) speaker stand (available
only in certain countries).
WS-FV10
WS-TV10
Screws
WS-WV10
Listening to the sound
Operation panel on the subwoofer
!
ON/
STANDBY
ON/STANDBY
indicator
First, turn down the volume on the amplifier.
The volume should be set to minimum before
you begin playing the program source.
1
Turn on the amplifier and select the
program source.
2
Press ! on the subwoofer.
The ON/STANDBY indicator on the
subwoofer lights up green.
3
Play the program source.
Power turns on and off
automatically
— Auto power on/off function
When the subwoofer is on (i.e, the
ON/STANDBY indicator lights up green)
and there is no signal input for a few minutes,
the ON/STANDBY indicator changes to red
and the subwoofer enters power saving
mode. While in this mode a signal is input to
the subwoofer, the subwoofer automatically
turns on (auto power on/off function).
To turn this feature off, slide the POWER
SAVE switch on the rear panel to OFF.
POWER
SAVE
Note
If you turn down the volume level of the subwoofer
too low, the auto power on/off function may
activate, causing the subwoofer to enter power
saving mode.
LEVEL
MODE
MOVIE
MUSIC
MIN
MAX
!
AUTO
OFF
9
GB