Sony SEN-231CD Instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony SEN-231CD. Sony SEN-231CD 24 stron.

Drukuj stronę
Playing in a Desired Order — Program Play
Locating the Loudest Portion of the Disc — Peak
Search
To program a whole disc
¢ Using DISC 1 to 5
After steps 1, 2 and 3:
1 Press DISC 1 to 5 to select the disc.
"AL" is displayed on the display.
N23
45
-.
12848
@
Ga ateee
proonw
(4
14 12 13 14 15
AL
{Ut}
M2345
8
Oo Glerees
eas
|
S6. Ta
Real
2 Goon to step 7.
@ Using DISC SKIP
After steps 1, 2 and 3:
1 Press DISC SKIP. "AL" is displayed on the display.
2 Press PROGRAM.
3 Go on to step 7.
The whole disc is programmed as one step.
To program while observing the disc labels
You can program the selections with the disc tray open.
To play the selections for side B
When the selections for side A have been played, the unit
will pause. ("B* lights up.)
Set the tape to the beginning of side B, then press & or tt.
The selections for side B will start playback.
To stop program play
Press @. The last selection number programmed will be
displayed.
To resume playback, press >. Play begins from the
beginning of the program.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel program play
Press CONTINUE and return to the continuous playback
mode. The program will be erased.
Skipping to the next selection programmed
Press >t during playback.
Going back to the beginning of the selection being
played
Press i<J during playback.
To cancel all the selections programmed
Press @ to cancel.
Notes
© The playing time for selection numbers higher than 20 will
not be added into the total playing time.
When selections have been programmed for sides A and
B, the total playing time displayed in stop mode will show
the selections programmed for side B and the total
playing time for side B.
18
The unit will scan a disc from beginning to end and
determined the loudest portion (peak level) of the disc, and
then play that portion repeatedly. In the continuous play
mode, only the disc in the play mode can be searched.
In
the program play mode, all of the programmed disc can be
searched. This function will make it easier for you to adjust
to the optimum level when recording on tape. You can use
this function in the continuous, shuffle and program play
modes,
To set peak search
Press PEAK SEARCH in the stop mode. 'PEAK' flashes on
the display. The entire tracks in a disc or program will be
searched automatically. "PEAK" lights up and the loudest
portion will be played repeatedly for 4 seconds. Adjust the
recording level on your tape deck according to the peak
level.
To stop peak search
Press @.
Press t# to pause at the first selection.
To start play immediately
Press >.
Note on peak search
The unit determines the loudest portion (peak level) of a disc by
searching it at fixed intervals. As a result, the portion searched
may differ from the actual peak level. In addition, this function
may determine different portions as the peak level for the same
disc. However, the difference between the portion searched and
the actual peak level is insignificant and will not present any
problem in adjusting the recording level.
The HST-231 adjusts the recording level automatically, so it is not
necessary to use this function.