Sony STR-DA3100ES - Fm Stereo/fm-am Receiver Informacje techniczne - Strona 13
Przeglądaj online lub pobierz pdf Informacje techniczne dla System stereo Sony STR-DA3100ES - Fm Stereo/fm-am Receiver. Sony STR-DA3100ES - Fm Stereo/fm-am Receiver 38 stron. Limited warranty (es products)
Również dla Sony STR-DA3100ES - Fm Stereo/fm-am Receiver: Specyfikacje (2 strony), Instrukcja łatwej konfiguracji (2 strony), Specyfikacje (2 strony), Ograniczona gwarancja (1 strony)
Drukuj stronę
The power MOS FETs in Sony's STR-DA7100ES are of a dramatically
different design, 50 to 70% thinner than the transistors used for the DA9000ES.
Even more important is the top molding of the transistor package, which is now
80% thinner than the previous design. The plastic itself is a resin of high thermal
conductivity, designed from the outset to encourage the flow of heat, not block it.
This thermal design—which runs counter to every practice in traditional
amplifiers—makes perfect sense considering the low heat generation of Sony's
S-Master Pro digital amplifier.
Sony takes advantage of this thermal design by coupling the heat sink to
the top of the MOS FET transistors, leaving the bottom to face a four-layer circuit
board, on which the transistors are surface mounted. Where most amplifiers
require thick aluminum heat sinks with many ribs to radiate the heat, the STR-
DA7100ES can use a single, simple sheet of metal with no ribs at all!
Extreme close-up of a single MOS FET output transistor (middle),
bonded to the L-shaped bracket of the heat sink. The transistor is
surface mounted to a four-layer circuit board (bottom).
On the left, the STR-DA7100ES power amplifier without the heat sink.
The four large black ICs in the middle are Sony's S-Master Pro 32-bit
LSIs, the CXD9773Q. On the right, the same circuit board with heat
sink in position.
Again, this runs counter to previous design practices for traditional
amplifiers. Typically, output transistors generate so much heat that they need to
ES Receivers v1.0
Page 13