Cisco ASR 5000 Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt sieciowy Cisco ASR 5000. Cisco ASR 5000 18 stron. Applying power and verifying the installation
Również dla Cisco ASR 5000: Instrukcja instalacji (33 strony), Procedura instalacji (8 strony), Instrukcja instalacji (37 strony)

Drukuj stronę

Re-Installing Chassis Sub-components

Follow the instructions below to connect the chassis to earth ground.

Step 1

Locate the chassis ground terminal on the lower-left corner of the rear of the chassis next to Power Filter Unit 1.

Step 2

Route the stranded copper ground cable to the chassis ground terminal.

Step 3

Crimp a 2-hole lug (Panduit type LCC6-10A-L) to the end of the ground cable using Panduit crimp tool part number

CT-1700 (die color: blue 24).

Step 4

Use a 3/8-inch nut driver or socket wrench to remove the nuts and washers from each of the two posts.

Step 5

Insert the lug connected to the grounding cable over the two posts.

Step 6

Secure the lug to the ground terminals with the nuts and washers you removed in step 4. The nuts should be torqued to

50 in-lb (5.65 N-m).

Step 7

Repeat step 2 through step 6 to connect the second ground cable to the chassis ground terminal on the lower-right corner

at the rear of the chassis next to Power Filter Unit 2.

Step 8

If you took steps to reduce the weight of the chassis prior to installation, refer to the instructions in the

Chassis Sub-components, on page 14

chapter.

Re-Installing Chassis Sub-components

If you performed the procedure in the

section, complete the procedures described below to re-install the sub-components of the chassis.

ASR 5000 Installation Guide

to re-install the components. Otherwise, proceed to the Application Card Installation

Reducing the Weight of the Chassis Prior to Installation, on page 6

Chassis Installation

Re-Installing