Cisco ASR 9000 Series Konfigurowanie - Strona 37

Przeglądaj online lub pobierz pdf Konfigurowanie dla Sprzęt sieciowy Cisco ASR 9000 Series. Cisco ASR 9000 Series 46 stron. Line card
Również dla Cisco ASR 9000 Series: Konfigurowanie ustawień sieciowych (26 strony), Podręcznik konfiguracji (46 strony), Podręcznik konfiguracji (50 strony), Podręcznik (24 strony), Podręcznik (44 strony), Skrócona instrukcja obsługi (7 strony)

Drukuj stronę
Cisco ASR 9000 Series Konfigurowanie
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Command or Action
Step 20
encapsulation {frame-relay | hdlc | ppp}
Example:
Router(config-if)# encapsulation
frame-relay | hdlc | ppp
Step 21
ipv4 ip-address mask
Example:
Router(config-if)# ip address 10.10.10.10
255.255.255.255
Step 22
no shutdown
Example:
RP/0/0/CPU0:router (config-if)# no
shutdown
Step 23
end
or
commit
Example:
RP/0/0/CPU0:router(config-sonet)# end
or
RP/0/0/CPU0:router(config-sonet)# commit
Step 24
show controllers sonet interface-path-id
Example:
RP/0/0/CPU0:router# show controllers
sonet 0/1/1/0
OL-26061-03
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Specifies the encapsulation type with the one of the following
keywords:
•
frame-relay—Frame Relay network protocol
•
hdlc—High-level Data Link Control (HDLC) synchronous
protocol
•
ppp—Point-to-Point Protocol
Assigns an IP address and subnet mask to the interface.
Removes the shutdown configuration.
Removal of the shutdown configuration eliminates the
Note
forced administrative down on the interface, enabling it to
move to an up or down state (assuming that the parent
SONET layer is not configured administratively down).
Saves configuration changes.
•
When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the running
–
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
–
router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
•
Use the commit command to save the configuration changes to
the running configuration file and remain within the
configuration session.
Verifies the SONET controller configuration.
How to Configure Channelized SONET/SDH
HC-353